Zarqa University Dr. Said Mohammad Electronics Chapter 2 1- Determine ID. A. 0 mA B. 1.893 mA C. 2.036 mA D. 2.143 mA Answer: Option B 2- What best describes the circuit? A. Full-wave rectifier B. Half-wave rectifier C. Clipper D. Clamper Answer: Option B 3. A diode is in the "________" state if the current established by the applied sources is such that its direction matches that of the arrow in the diode symbol, and V D ≥ 0.7 V for Si and VD ≥ 0.3 V for Ge. A. off B. on C. neutral D. quiescent Answer: Option B 4. The output frequency of a half-wave rectifier is ________ the input frequency. A. one-half B. twice C. equal to D. none of the above Answer: Option C 5. Determine Vo if E1 = E2 = 10 V. A. 9.3 V B. 10 V C. –10 V D. 0V Answer: Option B 1 Dr. S. Azar Zarqa University Dr. Said Mohammad 6. In the operation of a half-wave rectifier with a capacitor-input filter, the ripple factor can be lowered by ________ the value of the filter capacitor or ________ the load resistors. A. decreasing, decreasing B. decreasing, increasing C. increasing, decreasing D. increasing, increasing Answer: Option D 7. What best describes the circuit? A. Full-wave rectifier B. Half-wave rectifier C. Clipper D. Clamper Answer: Option C 8. Determine the value of the load resistor. A. RL = 5 k B. RL = 5.5 k C. RL = 6 k D. None of the above Answer: Option B 9. If the ac supply is 60 Hz, what will be the ripple frequency out of the half-wave rectifier? A. B. C. D. 30 Hz 50 Hz 60 Hz 120 Hz Answer: Option C 2 Dr. S. Azar Zarqa University Dr. Said Mohammad 10. A silicon diode in a half-wave rectifier has a barrier potential of 0.7 V. This has the effect of A. B. C. D. reducing the peak output voltage by 0.7 V. increasing the peak output voltage by 0.7 V. reducing the peak input voltage by 0.7 V. no effect. Answer: Option A 11. Determine the current level if E = 15 V and R = 3 k. A. B. C. D. 0A 4.76 mA 5 mA 5A Answer: Option B 12. Determine ID2. A. B. C. D. 29.40 mA 30.30 mA 14.70 mA None of the above Answer: Option C 13. Determine V2. A. B. C. D. 3.201 V 0V 4.3 V 1.371 V Answer: Option D 3 Dr. S. Azar Zarqa University Dr. Said Mohammad 14. What is the PIV for each diode in a full-wave center-tapped rectifier? Note: Vp(out) = peak output voltage. A. B. C. D. Vp(out) – 0.7 V Vp(out) + 0.7 V 2Vp(out) – 0.7 V 2Vp(out) + 0.7 V Answer: Option D 15. Determine ID2. A. 6.061 mA B. 0.7 mA C. 3.393 mA D. 3.571 mA Answer: Option C 4 Dr. S. Azar