2/20/23, 11:08 AM
1769 Embedded High Speed Counter: Member CtrlXScalar is invalid. Counter X is not used
ID: BF27357 | Access Levels: TechConnect
1769 Embedded High Speed Counter: Member CtrlXScalar is
invalid. Counter X is not used
Document ID
BF27357
Published Date
10/21/2021
Summary
1769 Embedded High Speed Counter: Member CtrlXScalar is invalid. Counter X is not used
Problem
Receiving a error message when attempting to apply changes to a Counter: Member
"Ctrl1Scalar" is invalid. Counter 1 is not used.
Embedded High Speed counter displaying error code: 16#0010 Mode or state
of module does not allow object to perform requested service.
Environment
Studio 5000 Logix Designer
https://rockwellautomation.custhelp.com/app/answers/answer_view/a_id/1133052
1/3
2/20/23, 11:08 AM
1769 Embedded High Speed Counter: Member CtrlXScalar is invalid. Counter X is not used
RSLogix 5000
1769-L24ER-QBFC1B
Solution
Check for and correct any conflicting configuration settings for Counter X that may result
in invalid configuration.
For Example:
Image bellow is an example of where Counter 1 was partially configured, but is not
enabled.
Recently Viewed
https://rockwellautomation.custhelp.com/app/answers/answer_view/a_id/1133052
2/3
2/20/23, 11:08 AM
FactoryTalk View SE : Playing a
sound wave file triggered by a
FactoryTalk Alarm and Events
alarm
1769 Embedded High Speed Counter: Member CtrlXScalar is invalid. Counter X is not used
CCW: error "One or more alarms
are configured without a
Message" on validation
RSNetworx assigning incorrect
I/O values to 32-point 1794 Flex I/O
DISCLAIMER
This knowledge base web site is intended to provide general technical information on a particular subject or subjects and is not an exhaustive treatment of such
subjects. Accordingly, the information in this web site is not intended to constitute application, design, software or other professional engineering advice or
services. Before making any decision or taking any action, which might affect your equipment, you should consult a qualified professional advisor.
ROCKWELL AUTOMATION DOES NOT WARRANT THE COMPLETENESS, TIMELINESS OR ACCURACY OF ANY OF THE DATA CONTAINED IN THIS WEB SITE AND MAY
MAKE CHANGES THERETO AT ANY TIME IN ITS SOLE DISCRETION WITHOUT NOTICE. FURTHER, ALL INFORMATION CONVEYED HEREBY IS PROVIDED TO USERS "AS
IS." IN NO EVENT SHALL ROCKWELL BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS PROFIT OR
DAMAGE, EVEN IF ROCKWELL AUTOMATION HAVE BEEN ADVISED ON THE POSSIBILITY OF SUCH DAMAGES.
ROCKWELL AUTOMATION DISCLAIMS ALL WARRANTIES WHETHER EXPRESSED OR IMPLIED IN RESPECT OF THE INFORMATION (INCLUDING SOFTWARE) PROVIDED
HEREBY, INCLUDING THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE, MERCHANTABILITY, AND NON-INFRINGEMENT. Note that certain
jurisdictions do not countenance the exclusion of implied warranties; thus, this disclaimer may not apply to you.
www.rockwellautomation.com
Copyright © 2023 Rockwell Automation, Inc. All Rights Reserved.
https://rockwellautomation.custhelp.com/app/answers/answer_view/a_id/1133052
3/3