TECHNICAL NOTE How to remove encoder port dust cover TENO-0364 Sales & Tech Support Date: 16/07/2020 Rev.: 1.0 By: Lee Nishio Page 1/2 PROPRIETARY INFORMATION OF SERVO-ROBOT INC. NOT TO BE USED OR REPRODUCED FOR ANY PURPOSE WITHOUT FIRST OBTAINING THE WRITTEN CONSENT OF SERVO-ROBOT INC. How to remove encoder port dust cover Required Tools 2.5mm allen wrench Procedure 1. Remove the 4 bolts that hold the encoder port dust cover in place. There are two on each side. 2. Screw two of the bolts into the threaded holes on the top of the encoder port dust cover. servorobot.com SERVO-ROBOT INC. 1370 Hocquart, Saint -Bruno, QC, Canada, J3V 6E1 Tel.(+1) 450.653.7868 Fax(+1) 450.653.7869 info@servorobot.com TECHNICAL NOTE How to remove encoder port dust cover TENO-0364 Sales & Tech Support Date: 16/07/2020 Rev.: 1.0 By: Lee Nishio Page 2/2 PROPRIETARY INFORMATION OF SERVO-ROBOT INC. NOT TO BE USED OR REPRODUCED FOR ANY PURPOSE WITHOUT FIRST OBTAINING THE WRITTEN CONSENT OF SERVO-ROBOT INC. 3. Firmly pull up to remove the encoder port dust cover. servorobot.com SERVO-ROBOT INC. 1370 Hocquart, Saint -Bruno, QC, Canada, J3V 6E1 Tel.(+1) 450.653.7868 Fax(+1) 450.653.7869 info@servorobot.com