430.245 ARTICLE 440 — MOTORS. MOTOR CIRCUITS. AND CONTROLLERS Table 430.250 Full-Load Current, Three-Phase Alternating-Current Motors The following values of full-load currents are typical for motors running at speeds usual for belted motors and motors with normal torque characteristics. The voltages listed are rated motor voltages. The currents listed shall be permitted for system voltage ranges of 110 to 120, 220 to 240, 440 to 480, and 550 to 600 volts. Synchronous-Type Unity Power Factor* (Amperes) Induction-Type Squirrel Cage and Wound Rotor (Amperes) Horsepower 115 200 208 230 460 575 2300 230 460 575 2300 Volts Volts Volts Volts Volts Volts Volts Volts Volts Volts Volts 4.4 2.5 2.4 2.2 1.1 0.9 1.6 1.3 Vl Va 3.7 3.5 1 6.4 8.4 3.2 4.8 4.6 4.2 2.1 1.7 l'/2 12.0 6.9 6.6 13.6 7.8 7.5 6.0 6.8 3.0 3.4 2.4 2 11.0 10.6 4.8 3.9 7.6 6.1 3 — 5 — 7'/2 — 17.5 16.7 9.6 15.2 25.3 24.2 22 11 9 — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — 32.2 30.8 28 14 11 46.2 42 21 62.1 78.2 59.4 27 74.8 54 68 17 22 34 92 88 80 40 27 32 120 114 104 52 41 50 60 150 143 130 52 177 169 154 65 77 62 16 75 100 221 211 192 77 285 273 343 396 528 248 312 96 124 360 480 _ 15 20 25 — — — 30 40 — 125 359 150 414 200 552 250 300 — — — — 350 — — — — 400 — — — — 450 — — — — — — — — 500 — — 48.3 10 ♦For 2.7 — — 21 63 26 32 26 83 41 33 104 52 42 123 61 49 20 155 78 62 15 99 26 202 101 81 20 156 125 126 101 144 302 151 121 240 192 31 37 49 253 180 400 201 161 25 30 40 302 242 60 361 414 289 336 72 477 382 95 515 412 103 590 472 118 53 — — — 83 — — — — 12 — — — — — — — — — — — — — — — — — — — — — — — — 90 and 80 percent power factor, the figures shall be multiplied by 1.1 and 1.25, respectively. Table 430.251(A) Conversion Table of Single-Phase LockedRotor Currents for Selection of Disconnecting Means and Controllers as Determined from Horsepower and Voltage Rating For use only with 430.110, 440.12, 440.41, and 455.8(C). Maximum Locked-Rotor Current in Amperes, Single Phase Rated Horsepower '/2 3/4 115 Volts 58.8 82.8 1 96 l'/2 2 120 144 3 204 5 7'/2 336 480 10 600 70-338 208 Volts 230 Volts 32.5 29.4 45.8 41.4 53 66 48 60 80 72 113 186 102 265 332 240 168 300 NATIONAL ELECTRICALCODE 2011 Edition ARTICLE 430 — MOTORS, MOTOR CIRCUITS, AND CONTROLLERS Table 430.248 Full-Load Currents in Amperes, Single-Phase Alternating-Current Motors The following values of full-load currents are for motors running at usual speedsand motors with normal torque characteristics. The volt ages listed are rated motor voltages. The currents listed shall be per mitted for system voltage ranges of 110 to 120 and 220 to 240 volts. 115 Horsepower Volts 200 Volts 208 Volts 230 Volts 2.4 2.2 3.2 2.9 3.6 '/6 4.4 Va 5.8 2.5 3.3 lA 7.2 4.1 Vi 9.8 5.6 4.0 5.4 7.9 9.2 7.6 8.8 20 11.5 11.0 24 13.8 13.2 18.7 30.8 44.0 55.0 Va 1 l'/2 2 3 5 V/l 10 13.8 16 34 56 80 100 19.6 32.2 46.0 57.5 4.9 6.9 8.0 10 12 17 28 40 50 Table 430.249 Full-Load Current, Two-Phase Alternating-Current Motors (4-Wire) The following values offull-load current are for motors running atspeeds usual for belted motors and motors with normal torque characteristics. Current in the common conductor of a 2-phase, 3-wire system will be 1.41 times the value given. The voltages listed arerated motor voltages. Thecurrents listed shall be permitted for system voltage ranges of 110 to 120, 220 to 240, 440 to 480, and 550 to 600 volts. Induction-Type Squirrel Cage and Wound Rotor (Amperes) 115 Horsepower Volts 460 575 2300 Volts Volts Volts Vi 4.0 2.0 1.0 0.8 4.8 2.4 1.2 1.0 — • 1 6.4 3.2 1.6 1.3 — l'/2 9.0 11.8 4.5 2.3 5.9 8.3 13.2 3.0 1.8 2.4 6.6 3.3 5.3 19 9.0 8.0 2 3 5 7'/2 15 20 25 30 40 50 60 75 100 125 150 200 NATIONAL ELECTRICAL CODE 230 Volts Va — — — 10 2011 E^l ltion 430.245 — 4.2 — — — — — 24 12 10 36 18 14 — _ — 47 23 19 — — 59 29 24 — — 69 35 28 — 90 45 36 — — — — — — — — 113 56 45 133 166 67 53 66 14 83 218 270 109 87 23 135 108 28 312 156 125 32 416 208 167 43 _ 18 70-337