25 MW GAS TURBINE AEG-KANIS Frame 5 INTRODUCTION Complete power generation unit of the skid built type consisting of a 25 MW simple cycle, single shaft, heavy duty gas turbine with diesel start, generator and all necessary auxiliary equipment. Overall frame length including all necessary components for operation is 39 meters, width is 3.2 meters, and overall high is 3.8 meter. OPERATION DATA The gas turbine unit is capable to start up without power from the grid. The unit can be operated as a black start unit. The unit can be remote started and synchronized from a control room. During its operational life time the unit has accumulated, under base load conditions, the following operational data: • Total fired hours: 2.230 hrs. • Fired starts: 1.674 hrs. • Operation hours: 1.928 hrs. TECHNICAL EQUIPMENT DATA GAS TURBINE DATA: Manufacturer of the unit: AEG-Kanis based on GE frame 5 gas turbine Gas turbine type: GE Frame 5 (5341N) Fuel: Distillate oil No. compressor stages: 16 No. turbine stages: 2 No. fuel nozzles: 10 Rpm: 5100 Net power output: 25.6 MW Net heat rate: 12,900 kJ/kWh Exhaust gas flow: 118 kg/s Exhaust gas temperature: 515 °C GENERATOR DATA Manufacturer of the generator: Rade Koncar Generator type: S 1726 – 2 Nominal power: 32 MVA Nominal active power: 25.6 MW Rpm: 3000 Cos phi: 0.8 Frequency: 50 Hz Nominal voltage: 10.5 kV Nominal current: 1,760 A Cooling principal: Air Type of excitation: Brushless GEAR BOXES: Load gear box manufacturer: Type: Auxiliary gear box Manufacturer: Graffenstade BA 1 EK Graffenstade STARTING DEVICE: Starting device: Detroit Diesel CONTROL EQUIPMENT: Gas turbine control system: Generator excitation: Generator protection: CO2 firefighting control make: Speedtronic Mark V ABB Unitrol 5000 ABB type REG 216 Kidde General remarks TERMS AND CONDITIONS: Price: On request On offer: One complete gas turbine unit of the skid built type Freight: Buyer is to arrange pickup and transportation from site location Site location: European Union Warranty: As is / Where is