How Do I Setup HP Deskjet 3630
hp 123 com setup dj3630 printer needs a proper setup before it can execute printing.
The HP printer can be connected to your computer in a variety of ways. You can choose
between a wired USB connection and a wireless USB connection. However, before you
can connect your printer to your computer, you must first install the HP 3630 printer
driver and software. As you can see, setting up a printer is a lot of work, which is why
we've put together this guide with step-by-step directions for the hp 123 com setup
dj3630. Simply follow the steps in the order listed, and your printer will be correctly
configured, connected, and ready to print by the time you reach the conclusion of this
page.
Initial setup for hp 123 com setup dj3630
Remove the HP 3630 printer from the box and discard the safety tape. Make sure the HP printer is close to the
PC and on a flat surface.
Connect one end of the power cable to the power supply and the other end to the rear of the HP Deskjet 3630
printer.
Press the power button to turn on the printer. Continue with the installation after the power button stops
flickering and is stable.
Don't worry, the printer will make some noise. It's the printer's hardware that needs to be adjusted and set up.
It's now time to arrange the ink cartridges in their proper locations.
Remove the ink cartridges from the box that came with the printer. Remove the tape off the back of the ink
cartridges as well as the contact point with care.
When you open the cabinet of the HP all-in-one 3630, the cartridge holder moves to the center of the machine
for cartridge installation.
Place the ink cartridges in the corresponding slots and firmly press them in.
Close the printer cover after the ink cartridge is in position.
The newly installed ink cartridges will be detected by the printer.
For a brief moment, the power button may flash. Before continue, wait for it to cease flashing.