P1224 Series Wall‑mount Field‑selectable Horn Strobes

advertisement
Fire Alarm Systems | P1224 Series Wall‑mount Field‑selectable Horn Strobes
P1224 Series Wall‑mount Field‑selectable
Horn Strobes
▶ Operates on either 12 V or 24 V
▶ Wide range of candela options; 15 cd and 15/75 cd for
12 V systems and 15 cd, 15/75 cd, 30 cd, 75 cd, 110 cd
for 24 V systems
▶ Easy candela selection
▶ Lower current draw
▶ Easy DIP switch selection for horn options
▶ Easy mounting with QuickClick™
▶ Can be synchronized with MDL Sync•Circuit™ module
The System Sensor® P1224 Series Wall‑mount
Field‑selectable Horn Strobes offer a range of candela
options at 12 V or 24 V in one unit. The candela selection is
easy and secure with the candela selection switch on the
back of the unit. To inhibit vandalism, once the unit is
locked into place with the QuickClick™ system, a special key
is needed to remove the unit. Even after the unit is installed
on the wall, workers doing maintenance or authorities
having jurisdiction (AHJs) doing inspections can easily read
the candela selection from the candela indicator on the side
of the lens without removing the unit from the wall.
P1224MC and P1224MCW only:
Listings and
Approvals:
CSFM 7125‑1209: 222 and 7135‑1209: 223
Factory Mutual 3014150
NYC/MEA (122‑02‑E and 126‑02‑E)
P1224MCK only:
Listings and
Approvals:
NYC/MEA (417‑03‑E)
Installation/Configuration Notes
Certifications and Approvals
Compatible Products
System Sensor® holds these Listings and Approvals:
The following products are compatible with the P1224
Series Horn Strobes:
All models:
Category
Product ID
Control
Panels
Compatible with all 24 V Bosch Control Panels when used
in continuous mode. For synchronization, use an SSMDL
or SSMDLW Synchronization Module.
Modules
SSMDL
Synchronization module (red)
SSMDLW
Synchronization module (white)
Listings and
Approvals:
UL ULSZ: Audible Signaling Appliances (UL464)
UL UUKC: Signaling Appliances and Equipment for Hearing Impaired (UL1971)
ULC CS549V602NK17954
ULC CS549V702NK13752
Complies with:
Americans with Disabilities Act (ADA)
National Fire Protection Association (NFPA 72)
Product Description
Mounting Considerations
Outdoor or Severe Environment Applications
www.boschsecurity.com
2 | P1224 Series Wall‑mount Field‑selectable Horn Strobes
When used in applications requiring the appliance to be
weather‑proof or outdoor listed, the P1224MCK model
must be used. It must be installed to the SSWBB
Weatherproof Back Box using the supplied mounting plate
and gasket.
Indoor Applications
These horn strobes are equipped with a mounting plate that
can be mounted to the indicated back boxes for the
indicated applications:
Conduit
Applications
Surface
Mounted
Flush
Mounted
Single‑gang
•1
four‑inch square
•
•2
•
1
Flush mounting on a single‑gang box requires using an
SSS‑MP Small Footprint Mounting Plate.
2 Surface
mounting on a four‑inch square back box requires
the use of a surface mount back box skirt (SSBBS or
SSBBSW).
Mechanical Properties
Candela Selections:
15 cd1, 15/75 cd1, 30 cd2, 75 cd2,
or 110 cd2
Dimensions (HxWxD)
with universal plate:
5.6 in. x 5 in. x 2.9 in.
(14.3 cm x 12.7 cm x 7.5 cm)
Dimensions (HxWxD)
with small footprint plate:
5.6 in. x 3.4 in. x 2.3 in.
(14.3 cm x 8.6 cm x 5.9 cm)
Horn Audibility
(UL Reverberant Room)
at 10 ft (3 m):
75 dBA
Material:
Molded plastic enclosure incorporating a Xenon flashtube.
Weight without mounting plate:
8.8 oz. (0.25 kg)
1 When set at these settings (15 cd or 15/75 cd) the devices
automatically work on both 12 V and 24 V power supplies.
The 15/75 cd selection is listed at 15 cd per UL1971 but
provides 75 cd on axis.
2
Do not exceed:
The strobe is not listed for 12 V operating voltages when
set to these selections (30 cd, 75 cd, and 110 cd). When
using a 12 V control panel, this device yields required light
output only in the 15 cd and 15/75 cd settings.
•
Power Requirements
Strobe Cautions
•
•
The voltage range for the chosen nominal voltage (8 V
to 17.5 V for 12 V nominal or 16 V to 33 V for 24 V
nominal)
70 strobes and a maximum line impedance of 4 Ω per
loop when using a synchronization module
The maximum line impedance of the control panel
Wiring
Note
These strobe units are not recommended for
use in coded or pulsed signaling circuits.
The input terminals accept wires with diameters between
18 AWG (1.2 mm) and 12 AWG (2.3 mm).
Parts Included
Quant.
Component
1
P1224 Horn Strobe
1
SSD‑MP Universal Mounting Plate
1
Hardware pack
1
Literature pack
Technical Specifications
Maximum Operating Horn Current 57 mA RMS
(12 VDC):
Maximum Operating Horn Current 57.58 mA RMS
(12 VFWR):
Maximum Operating Horn Current 44.4 mA RMS
(24 VDC):
Maximum Operating Horn Current 45.7 mA RMS
(24 VFWR):
Maximum Operating Strobe Current (12 VDC):
15 cd: 127 mA RMS
15/75 cd: 27 mA RMS
Maximum Operating Strobe Current (12 VFWR):
15 cd: 112 mA RMS
15/75 cd: 135 mA RMS
Maximum Operating Strobe Current (24 VDC):
15 cd: 59 mA RMS
15/75 cd: 9 mA RMS
30 cd: 90 mA RMS
75 cd: 160 mA RMS
110 cd: 209 mA RMS
Maximum Operating Strobe Current (24 VFWR):
15 cd: 64 mA RMS
15/75 cd: 4 mA RMS
30 cd: 93 mA RMS
110 cd: 08 mA RMS
Voltage (Nominal Input):
12 VDC or FWR unfiltered or
24 VDC or FWR unfiltered
Voltage (Operating Range):
12 V: 9.5 V to 17.5 V;
24 V: 16 V to 33 V
Environmental Considerations
Relative Humidity:
Up to 95%, non‑condensing
Trademarks
Temperature (operating):
Indoor use: +32°F to +120°F
(0°C to +49°C)
Outdoor use: +32°F to +150°F
(0°C to +66°C)
QuickClick™ and Sync•Circuit™ are trademarks of System Sensor® in the
United States and other countries.
System Sensor® is a registered trademark or a trademark of Pittway International, Ltd. in the United States and other countries.
P1224 Series Wall‑mount Field‑selectable Horn Strobes | 3
Ordering Information
P1224MC Horn Strobe (red)
P1224MC
P1224MCW Horn Strobe (white)
P1224MCW
P1224MCK Weatherproof Horn Strobe
P1224MCK
Accessories
SSS‑MPW Small Footprint Mounting Plate
(white)
Used when mounting to a single‑gang box
SSS-MPW
SSBBS Back Box Skirt (red)
SSBBS
SSD‑MPW Universal Mounting Plate (white)
SSD-MPW
SSS‑MP Small Footprint Mounting Plate
(red)
Used when mounting to a single‑gang box
SSS-MP
SSBBSW Back Box Skirt (white)
SSBBSW
SSD‑MP Universal Mounting Plate (red)
Used when mounting to a standard four‑inch
square back box
SSD-MP
SSWBB Weatherproof Back Box
4.33 in. (11 cm) square by 1.55 in. (4 cm)
deep
SSWBB
www.boschsecurity.com
4 | P1224 Series Wall‑mount Field‑selectable Horn Strobes
Americas:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: +1 800 289 0096
Fax: +1 585 223 9180
security.sales@us.bosch.com
www.boschsecurity.us
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: +31 40 2577 330
emea.securitysystems@bosch.com
www.boschsecurity.com
© Bosch Security Systems Inc. 2010 | Data subject to change without notice
T1123713547 | Cur: en-US, V6, 4 Jul 2010
Asia-Pacific:
Represented by
Robert Bosch (SEA) Pte Ltd, Security Systems
11 Bishan Street 21
Singapore 573943
Phone: +65 6258 5511
Fax: +65 6571 2698
apr.securitysystems@bosch.com
www.boschsecurity.com
Download