BRUCK LIGHTING SYSTEMS
15774 Gateway Circle Tustin, CA. 92780
www.brucklighting.com
For more assistance with technical questions please call our
technical support staff at (714) 259-9959. You can also
contact us by email at info@brucklightingsystems.com.
INSTALLATION AND WIRING DIAGRAM
V/A
2"
4 1/2"
59"
V/A
ART. NO.
300 052bz
300 052ch
300 052mc
bronze
chrome
matte chorme
52"
IMPORTANT SAFETY INSTRUCTIONS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
Read all of these installation Instructions before installing the track system.
Save these instructions and refer to them when additions to or changes in the track configuration are made.
THIS PRODUCT MUST BE INSTALLED BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED, IN ACCORDANCE WITH LOCAL NEC CODE.
FOR USE WITH V/A NETWORK ONLY.
Do not install the track or any part which contains exposed wires less then 7 feet from the floor.
Do not install this rail in damp or wet locations.
Do not install fixture assembly closer than 6 inches from any curtain, or similar combustible material.
Disconnect electrical power before adding to or changing the configuration of the track.
Do not attempt to energize anything other than lighting rail fixtures on the rail. To reduce the risk of fire and electrical shock, do not attempt to connect
power tools, extension cords, appliances, and the like to the rail.
Total wattage of the system must not exceed 75 or 150W supplied by the low voltage transformers.
Suspension cables are conductive and should not touch other parts of the track or crossed.
CAUTION! Lamps and fixtures become hot during operation.
This track system MUST BE HARD WIRED. For all the wire connections, use Listed Wire Nuts.
Secondary connections must be clean and tight to avoid arcing and overheating!
Warranty is void in case of unauthorized modifications and/ or improper use.
READ ALL OF THESE INSTALLATION INSTRUCTIONS BEFORE INSTALLING THE FIXTURE
Mounting The Transformer And Canopy
- Connect power supply cables to the transformer (A),
ground wire should be properly grounded.
A
B
- Screw mounting plate (B) to J-box with mounting
screws (C).
ground wire
C
- Slide canopy cover (E) over transformer and
mounting plate (B) and tighten set screws (D).
Lamp Installation
E
D
- Insert a Bi-Pin lamp (F) into the socket (G) and screw
on desired glass.
G
Shortening Length
- The chandelier can be shortened to the desired
length by loosening the two allen screws (H) located
to the side of the power feed.
- Once the desired length is reached, tighten the allen
screws (H) and trim off any excess cables from below.
F
H