SECTION 15728
SHELL AND TUBE HEAT EXCHANGER
PART 1 - GENERAL
1.01
GENERAL
The Bidding and Contract Requirements, Division 1 - General Requirements, section
15010 - General Provisions, and section 15050 - Basic Materials and Methods shall apply
to this section.
1.02
SCOPE
Provide and install the shell and tube heat exchanger as shown on the drawings and
specified herein.
1.03
QUALITY ASSURANCE
The shell and tube heat exchanger shall be manufactured to meet ASME codes and shall
be hydrostatically tested at the factory at pressures higher than the unit will be subjected
to in the field. The ASME "U' symbol shall be stamped on the heat exchanger. Each unit
shall be registered as required with the National Board of Boiler and Pressure Vessel
Inspectors.
1.04
SUBMITTALS
Provide shop drawings on this equipment as described in section 15010, 1.04.
PART 2 - PRODUCTS
2.01
SHELL AND TUBE HEAT EXCHANGER
The shell and tube heat exchanger shall be completely factory assembled and shall be of
the type and capacity as shown on the drawings. The heat exchanger shall be
manufactured by BELL & GOSSETT. Units fully equal to the specified unit and
manufactured by ARMSTRONG or TACO are acceptable.
A.
Materials
1.
2.
3.
4.
5.
Shell - steel.
Tubes - copper.
Tube sheets - steel.
Tube supports - steel.
Heads - cast iron or steel.
15728-1
11/13
SHELL AND TUBE HEAT EXCHANGER
SECTION 15728
PART 3 - EXECUTION
3.01
INSTALLATION
The heat exchanger shall be installed as recommended by the manufacturer and as
detailed on the drawings.
END OF SECTION
15728-2
11/13