SIP Strobe Now supporting voice mailbox Message Waiting Indication The IP Endpoint Company When installed, the wall-mounted SIP Strobe operates as a visual alerting device. The device can be set up as part of a ring group (call group) with the Strobe engaged as notification of incoming calls. The SIP Strobe may also be activated by being part of a Multicast group. When audio is detected on a specific Multicast address and port, the strobe will activate. Through a web page setup, you can have the SIP Strobe respond to message waiting signals by blinking. When the message has been heard, the strobe stops blinking. User selectable scenes for blink rate and brightness for each of the activation modes. Specifications Users may also use CyberData's HTTP command set to directly access the strobe’s functions. Ethernet I/F 10/100 Mbps Protocol SIP RFC 3261 Compatible Power Input PoE 802.3af compliant or +8 to +12VDC @ 1000mA Regulated Power Supply Light power Up to 90 candela (user-selectable) Flash rate 5 user-defined scenes Program or listen to up to 10 multicast addresses LED MTBF 100,000 Hours SIP activation On-Board Relay 1A at 30 VDC Mailbox Message Waiting Indication Operating Temperature -40° C to +55° C (-40° F to 131° F) Multicast activation Payload Types G711, A-law and µ-law Dimensions 4.5 inches [115 mm] Length 2.1 inches [55 mm] Width 4.5 inches [115 mm] Height Warranty 2 years limited Weight Boxed Weight 1.0 lbs. (0.45 kg) 2.0 lbs. (0.90 kg) Part Number 011087 Features 5 user blink scenes available User configurable brightness Meets ADA requirements for telephony signaling and notification Cisco SRST support Event-controlled relay Tamper sensor Web-based setup PoE-powered Use areas include: Sales and support mailbox indication Classrooms Banks or financial institutions Court rooms Manufacturing warehouses Office Indoor only The IP Endpoint Company CyberData Corporation 3 Justin Court, Monterey, CA 93940 831.373.2601 Fax: 831.373.4193 www.cyberdata.net SIP Strobe Typical Installation Generic PoE Switch 1 SIP Strobe SIP Strobe 2 3 4 5 SIP Strobe 6 IP Phone IP PBX Server Mounting Options Pre Drill Holes on Wall 121001A Screw Accessory Kit Wall Cutout Opening Network Cable to J1 Backplate Wall Cutout Backplate accept Single Gang Box or Two Gang Box Cable Entry Slot Opening Wall Cutout Backplate Gang Box Mounting Screw (4x) Single Gang Box use two CyberData Corporation 3 Justin Court, Monterey, CA 93940 831.373.2601 Fax: 831.373.4193 www.cyberdata.net 930444G/151027