4 Post Lift: CL 8,000 CSP INSTALLATION manual CL 8,000 CSP SpeciÀcations 11 TOP OF RUNWAY HEIGHT LOCK POSITIONS 72” 76” FLOOR TO MAX BOTTOM OF RUNWAY [1828.8 mm] [1930.4 mm] 82” [2082.8 mm] FLOOR TO MAX TOP OF RUNWAY WARNING: If ANCHORING Post (optional) to Àoor, square up all measurements and wait till your Lift is assembled in it’s entirety. Once fully assembled then anchor Post to Àoor. 74½” 72½” 68¼” 64¼” 60” 55½” 51¼” 47” 42¾” 38½” 21” 156½” [3975.1 mm] 175¼” [4451.35 mm] 88¼” [1930.4 mm] 103¼” 37½” [952.5 mm] [2622.55 mm] 18½” [469.9 mm] 37” [940 mm] 204½” [5194.3 mm] FIGURE 1 (Vehicle Lift Speci¿cations Drawing) We reserve the right to make changes in speci¿cations without notice and without making changes retroactive. COMPLETE HYDRAULIC SERVICE & SALES, INC. Volume: 01.06.2009 04:23 PM www.CompleteHydraulic.com 5 of 43 4 Post Lift: CL 8,000 CSP INSTALLATION manual CL 8,000 CSP SpeciÀcations WARNING: If ANCHORING Post (optional) to Àoor, square up all measurements and wait until your Lift is assembled in its entirety. Once fully assembled, then anchor Post to Àoor. FRONT OF Lift Allow at least 9’ for T-rod installation. 10¼” [260.35 mm] Post Floor Plates 10¼” X 12” 29½’ CENTER LINE Passenger’s Side [8991.6 mm] 156½” [3937 mm] Driver’s Side 0 3” m] 20 .8 m 59 175¼” [2 [4457.7 mm] [260.35 mm X 304.8 mm] 103¼” [2590.8 mm] 51½” [1308.1 mm] 51½” [1308.1 mm] 10¼” [260.35 mm] 12” [304.8 mm] BACK OF Lift Allow at least 6’ for Lock Rod installation. FIGURE 2 (Vehicle Lift Layout Drawing) Note for Figure 2 - We recommend 12” (INCHES) between the post and the nearest wall. We reserve the right to make changes in speci¿cations without notice and without making changes retroactive. COMPLETE HYDRAULIC SERVICE & SALES, INC. Volume: 01.06.2009 04:23 PM www.CompleteHydraulic.com 6 of 43