A Three Phase, Double Conversion, PWM, High Performance UPS...
True On Line Operation
The OnLine Power Industrial
Grade 3000 represents the highest
performance on line UPS technology in
which the transistorized inverter is continuously providing superior power protection for today’s rapidly changing industrial and data processing hardware platforms.
High Reliability
Industrial Grade 3000 offers the highest level of reliability available in true on line UPS Systems.
Observed mean time between failure (MTBF) is in
excess of 400,000 hours. This has been achieved through
conservative design philosophy, extremely low parts
count, state of the art logic & control circuitry and built-in
static and maintenance bypass switches.
High Efficiency
Industrial Grade 3000 is the most cost effective solution to
your power problems. With 92% operating efficiency at full
load, the input power requirement is significantly lower than
other competitive products. Higher efficiency also reduces air
conditioning requirements. As a result, “cost of ownership” is
among the lowest in the industry.
Transistorized Inverter
Continuous Duty Static Switch
UPS 3000 static switch is a continuous duty, fully rated assembly providing a means of transferring the critical load from
inverter to reserve input during excessive overloads and
fault clearing.
Maintenance Bypass Switch
Industrial Grade 3000 has a built in maintenance bypass
switch in the UPS cabinet. The switch allows the critical load to be directly fed from the utility during routine maintenance, a feature most desired by field service engineers and technicians.
Ease of Installation
Industrial Grade 3000 is designed to accommodate conduit/ cable entry from the top
or bottom. All power cables for rectifier
input, maintenance bypass input & system output terminate on individual
terminal blocks with Allen screws,
eliminating the need for pressure connectors. The unit
can be placed against the
wall as no rear access is
required.
• UL LISTED
• UL 924 (Optional)
• High Reliability
• High Efficiency
• Acoustically Quiet
• Ease of Installation
• Full Double Conversion
• Fully Rated Static Switch
• Maintenance Bypass Switch
• Transistorized Inverter Suitable for
100% Non-Linear Loads with 3.5
Crest Factor
• 5 Year Factory Warranty
(3ø Uninterruptible Power Supply)
Switching mode power supplies (SMPS) are an integral part of
practically all industrial data Processing/ Computing equipment
used in today’s industrial applications and office environments.
These SMPS present highly non-linear loads to the UPS. Non-linear loads have voltage wave form distortion. Industrial Grade
3000 utilizes state-of-the-art, IGBT’s pulse width modulated
(PWM) inverter technology that produces an output voltage
wave form compatible with today’s automated industrial equipment and computer systems.
• 15 to 100 kVA
Industrial Grade 3000
The TANK
STANDARD FEATURES
OPTIONS
• UL 924
• Main Input Breaker
• Remote Emergency Power OFF (REPO)
Stat ion with 50 ft. Cable
• Reserve Input Circuit Breaker
• Transistorized Inverter
• Thermal Remote Emergency Power OFF
(REPO) Station with 50 ft. Cable
• Continuous Duty Static Switch
• IBM AS/400 Interface Cable and Connector
• 5% Input Harmonic Distortion Filter
• Maintenance Bypass Switch
• Remote Panel w/Summary Alarm
• Power Cable Terminal Blocks
• Computer Grade Bypass Transformer
• IBM AS/400 Interface Circuitry
• Power Distribution Panel
• System Monitoring
• Emergency Power OFF (EPO)
• Multiple Software
• Special Paint
INDUSTRIAL GRADE 3000 SPECIFICATIONS
ENVIRONMENT
INPUT
**Voltage . . . . . .
Voltage Range . . .
Wiring . . . . . . . . .
Power Factor . . . . .
***Frequency Range
Power Walk-In . . . . .
Magnetizing In Rush .
Current Limit . . . . . . .
.
.
.
.
.
.
.
.
.
..
..
..
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
208Y/120, 480Y/277 VAC
+10%, -15%
3 Phase, 3 Wire and Ground
0.85
60 Hz. +5%
20 to 100% in 15 Sec.
5-8 times normal Full Load current
100-125% of normal Full Load current
adjustable
Protection . . . . . . . . . . . . . . . . . Molded case circuit breaker with single
phase protection. Current limit fuses.
OUTPUT
Voltage 60 Hz . . . . . . . . . . . . . 208Y/120 or 480Y/277 VAC
Wiring . . . . . . . . . . . . . . . . . . . 3 Phase, 4 Wire and Ground
Voltage Regulation
Balanced Load . . . . . . . . . . . +0.5%
50% Unbalanced . . . . . . . . . +2%
100% Unbalanced . . . . . . . +5%
Frequency (Regulation) . . . . . . +0.1%
Efficiency . . . . . . . . . . . . . . . 92%
Load Power Factor . . . . . . . . 0.7 Lag to 0.9 Lead
Phasing Balance
Balanced Load . . . . . . . 120˚ +1˚
50% Unbalanced . . . . . 120˚ +1˚
100% Unbalanced . . . 120˚ +3˚
Total Harmonics . . . . . . 3% RMS Max.
Single Harmonics . . . . 1% RMS Max.
Overload at . . . . . . . 125% of Full Load for 10 Minutes.
Nominal . . . . . . . . . 150% of Full Load for 30 seconds.
Current Limit . . . . . 150% FL current at reduced voltage
Fault Clearing Capability . . . 300-400% sub-cycle
Voltage Transients
50% Load step . . . . . . +3%
100% Load step . . . . . +5%
Loss or return of redundant module . . . +3%
Automatic transfer . . . +3% Load to Bypass
Manual Return . . . . +1% Load to UPS
Response Time . . Recovery to 99% of steady
state in 1 cycle.
IG3-6022E-404
© Copyright OnLine Power, Inc. All rights reserved.
R
Operating Temp. . . . . . . . . . . UPS: 0˚ to 40˚C. (32˚ to 104˚F.)
Battery: 20˚ to 30˚C. (68˚ to 86˚F.)
Non-operating Temp. . . . . . . . -20˚ to 70˚C. (-4˚ to 158˚F.)
Battery Temp. . . . . . . . . . . . . Average annual temperature less than
27˚C. (80˚F.). Peak temperature less
than 43˚C. (110˚F.) for more than
24-hour period.
Relative Humidity . . . . . . . . . . 5-95% Non-condensing
Altitude
Operating . . . . . . . . . . . . . Up to 7,500 ft. (2,286 m)
Non-operating . . . . . . . . . . Up to 10,000 ft. (3,048 m)
Acoustical Noise . . . . . . . . <45 dB at 6 ft.
Dimensions . . . . . . . . . . . . . . Width
Depth Height
34" x 34" x 69"
kVA
INPUT
OUTPUT
SIZES VOLTAGE VOLTAGE
15
20
25
30
37.5
50
62.5
75
100
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
480 VAC
480 VAC
480 VAC
480 VAC
480 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
208 VAC
480 VAC
MODEL
NUMBERS
UP015B0500T3
UP015H0900T3
UP020B0500T3
UP020H0900T3
UP025B0500T3
UP025H0900T3
UP030B0500T3
UP030H0900T3
UP037B0500T3
UP037H0900T3
UP050B0500T3
UP050H0900T3
UP062H0500T3
UP062H0900T3
UP075H0500T3
UP075H0900T3
UP100H0500T3
UP100H0900T3
BATTERY CABINET WEIGHT
15 Min 30 Min 45 Min
BTU's/HR
UPS
WEIGHTS
4,440
1,655 LBS
1,243
1,495
2,900
5,900
1,998 LBS
1,618
2,050
3,270
7,400
2,092 LBS
1,800
2,144
3,900
8,900
2,186 LBS
2,144
2,800
4,100
11,100
2,331 LBS
2,144
2,800
4,900*
15,000
2,566 LBS
2,800
4,940*
5,600*
CONSULT FACTORY
* Two (2) Battery Cabinets.
** Other input voltages available;
contact factory sales department for more information.
*** For modified units & 50 Hz models, consult factory
Specifications are subject to change without prior notification.
5701 Smithway St.
Commerce, CA 90040
Phone: (800) 227-8899
Fax: (323) 721-3929
www.onlinepower.com