LED
Installation Instructions
POPS09 Wall Mount
Read all instructions before installation.
Avoid touching the LED module during installation.
The POPS09 Wall Mount
*Do not install this luminaire outdoors unless equipped with the ‘WL’ Wet Label option!
B
C
A
shape may vary.
E
F
Switch box by others
I
G
H
See other side for
wiring instructions.
Installation Steps:
D
B
1. Refer to the wiring diagrams on the other side of this sheet to determine appropriate connections for the project.
2. Connect supply wires to driver (A) input wires per wiring diagram.
3. Attach mount plate (B) to octagon box so that driver (A) is located within the box.
4. Connect polarized plug (D) from luminaire to socket on driver (A).
5. Align threated studs (E) with sockets (C) on mounting plate.
6.
Wet Label:
7.
Wet Label:
Maintenance & Cleaning:
No regular maintenance is required. The LED module & driver are non-serviceable components with a 50,000 hour operating life to 70%
initial output. At 100,000 hours light output will be approximately 50% of initial.
3760 West Fourth Street
|
Winona, MN 55987
|
800-328-5291
|
www.winonalighting.com
Revision 4/13
POPS! WIRING
All POPS! models are available with Dimming and Non-Dimming internal drivers. Non-Dimming drivers accept 90V-264V AC
(ND120V code) and 11-15V AC (ND12V code). All Dimming drivers require require low voltage DC power supply to operate.
Size and model of the power supply will vary according to size of installation and other requirements.
Do not connect line voltage to Dimming drivers!
Do not make live connections!
POWER SUPPLY / DIMMING
All POPS models are available with Dimming and Non-Dimming internal drivers in both 120V and 277V input versions.
Dimming drivers require a 0-10V fluorescent-type dimming control.
NON-DIMMING INSTALLATIONS
Read all instructions before installation.
Do not make live connections!
Connect WHITE wire to power NEUTRAL.
Connect BLACK wire to power HOT.
Connect GREEN wire to power GROUND.
To other
STEP
fixtures
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
DIMMING INSTALLATIONS
The integral dimming driver is designed to the 0-10V IEC dimming specification 60929 and is compatible with common
0-10V dimmers and dimming systems. Do NOT connect line voltage to dimming input wires.
Connect WHITE wire to power NEUTRAL.
Connect BLACK wire to power HOT.
Connect VIOLET wire to POSITIVE INPUT of Dimming Control.
Connect GREY wire to NEGATIVE INPUT of Dimming Control.
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
VIOLET
GREY
VIOLET
GREY
VIOLET
GREY
To other
STEP
fixtures
VIOLET
GREY
VIOLET
GREY
VIOLET
GREY
0-10V (+)
Dimmer (-)
To other
STEP
fixtures
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
WHITE
BLACK
GREEN
120V
or
277V
Page 2 of 2
3760 West Fourth Street
|
Winona, MN 55987
|
800-328-5291
|
www.winonalighting.com
Revision 4/13