PLX Magnetic
Installation Instructions
1
2
Prepare Light Fixtures
400W / 600W Lamp: Std Bracket Mt
Slide Bolts into Channel
3
Attach Brackets
10mm Socket
• Arrange boxed light fixtures on floor in specified
mounting locations; remove fixtures from boxes.
• Slide 2x bolts (supplied) into the center channel
(1 bolt at either end of the housing).
• Ensure that you have the necessary tools available.
• Place two brackets (supplied) onto the bolts with
the appropriate end for your mounting structure
facing upward. • Begin to thread on the two nuts (supplied) but leave
them loose for adjustment.
5
Orient Brackets
• Orient the two brackets so that they are facing
opposite directions and the mounting structure
will run parallel to the fixture.
Align Housing with Mounting Structure
• Raise housing at a 45° angle to the mounting
structure, then rotate it parallel so that both brackets are aligned above mounting structure.
6
Hang Housing
• Lower housing so that both brackets securely hook
over top of mounting structure.
• Tighten down the two nuts.
!
ATTENTION: Install in accordance with national and local building and electrical codes.
© P.L. Light Systems, 4800 Hinan Drive, Beamsville, Ontario, Canada, L0R 1B1 T: 905.563.4133 Toll Free: 1.800.263.0213 www.pllight.com
!
PAGE
1 of 2
PLX_Install_ Std_Bracket_08.15
4
Installation Instructions
7
PLX Magnetic
8
Install Lamp
• Insert lamp into lamp socket and twist clockwise
until lamp is securely installed.
400W / 600W Lamp: Std Bracket Mt
Insert Reflector into Collar
• Place reflector collar on flat, solid surface.
• Slide reflector into collar at an angle, so that
outer rim is inserted beneath the collar tabs.
9
Adjust and Secure Reflector
• Using both hands, adjust the reflector from the
inside, by gently pressing outwards until the outer
rim fits securely beneath the collar tabs on all sides.
(Note: Wear cotton gloves or wash hands thoroughly with soap & water
to remove any grime/oils before handling reflector.)
• F
or High Pressure Sodium (HPS) model,
proceed to Step 12.
10
Position Lens (Metal Halide ONLY)
11
Secure Lens (PLX Metal Halide ONLY)
12
Attach Reflector Assembly
Note: This step is for the Metal Halide (MH) model ONLY.
• Place reflector assembly on a flat, solid surface with
collar facing up.
• Position glass lens on top as shown.
(Note: Wear cotton gloves or wash hands thoroughly with soap & water
to remove any grime/oils before handling lens.)
!
Note: This step is for the Metal Halide (MH) model ONLY.
• Secure lens in place with supplied clips as shown.
• Raise reflector assembly* to the housing.
• Lift free end of reflector clip (on fixture housing)
• Position reflector assembly so that the edge of the
collar sits flush against the fixture housing
• Lower clip to secure reflector assembly in place.
*MH Model: Align so that lamp slides between lens & reflector
ATTENTION: Install in accordance with national and local building and electrical codes.
© P.L. Light Systems, 4800 Hinan Drive, Beamsville, Ontario, Canada, L0R 1B1 T: 905.563.4133 Toll Free: 1.800.263.0213 www.pllight.com
!
PAGE
2 of 2
PLX_Install_ Std_Bracket_08.15
MH Model Shown