MICRO ADJUSTABLE MOUNTING
BRACKET INSTALLATION
INSTRUCTIONS
Installation tools:
• 1/4” Allen wrench
• 1/2” Wrench or 1/2” socket with ratchet
• 11/32 drill bit with drill
Included hardware:
A Qty. (1) Adjustable mounting bracket
B Qty. (4) 5/16” Mounting bracket bolts
C Qty. (4) 5/16” Lock nuts
D Qty. (4) 5/16” Fender washers
E Qty. (1) 5/16” White thru-hull bushing (optional)
MOUNTING OPTIONS
IMPORTANT: In all options the bottom of the Micro Driver Unit must be mounted above the water line of the boat.
DECK MOUNT
TRANSOM MOUNT
(FIG. 1)
NOTE: Before drilling holes, mock up Micro unit with spike
installed and attached to mounting bracket to
ensure no interferences in the desired mounting location.
Place bracket within 3” of
edge of mounting surface
Adjustable
mounting
bracket
(FIG. 2)
Place bottom edge of bracket even or
higher than the boat’s water line
Adjustable
mounting
bracket
Mark and drill holes with 5/16” drill
bit and install hardware as shown.
D
B
C
Mark and drill holes with 5/16” drill
bit and install hardware as shown.
1/4” Allen
Wrench
C
3”
1/4” Allen Wrench
D
C
Figure 2
Figure 1
THRU-HULL BUSHING FOR POWER-CORD
IMPORTANT: If using the thru-hull bushing (E) it must be installed above the water line.
Drill a hole into boat with 11/32" drill bit, insert bushing (E) and route power-cord through to 12 volt power source.
MICRO ADJUSTABLE MOUNTING
BRACKET INSTALLATION
INSTRUCTIONS (continued)
ADDITIONAL MOUNTING OPTIONS
ADAPTER PLATE (FIG. 3)
To order go to power-pole.com
or an authorized dealer.
Adapter plate
Adapter plate
Adjustable
mounting bracket
C
B
D
1/4” Allen wrench
Figure 3
Adjustable mounting bracket
TRANSOM CLAMP
(FIG. 4)
To order go to power-pole.com
or an authorized dealer.
Transom clamp
1/4” Allen wrench
C
B
Figure 4
Need help? Contact our Technical Support Team at 1 + 813.689.9932 Option 2
©2015 all rights reserved. Power-Pole Shallow Water Anchor U.S. Patent No. 6,041,730