Fixture Type
APPROVAL
Lamp Type
Job Ref. / Location
SERIES R
APPLICATION
Recessed emergency systems are ideal for use in commercial and
institutional facilities where a concealed, easy - to - service system
is desired. The buff white fixtures blend with the ceiling and do note
detract from the decor or architectural detail of the space.
STANDARD FEATURES
qBuff white color to match ceiling.
q Access panel for ease of installation & service from above ceiling.
qSupplied with four (4) combination 1/2" & 3/4" knockouts for through wiring and 24" hanger bars.
qPlug in wiring harness provided for easy installation to 120/
277 volt 60 Hz. input.
qMounting flexibility can be used in both "T" grid suspended ceilings and non-accessible "solid" ceilings.
qAvailable with two PAR36 lighting fixtures.
qFactory cycle tested for reliability.
q Shipped assembled, ready to install.
CHARGER/BATTERY
q Solid state, patented POWER PULSE* charger.
q Sealed lead acid recombination maintenance free battery – 8 year life expectancy. (See optional batteries.)
q Low battery voltage disconnect, brownout, power-on latch, solid state switch.
q Controls: Red LED power-on indicator, push to test switch.
q Choice of replaceable maintenance free batteries – supplied standard with recombination lead calcium. Optional with nickel cadmium or pure lead.
q Temperature compensated charger.
q D.C. fuse – (1) 5 amps. *Patent No. 4890004
6 Volt - 12 Volt Recessed
Emergency Lighting
Smallest Ceiling
Footprint in the Industry!
Only 5" in diameter
Shown with
PAR 36 Fixture
SELECTION GUIDE
MODEL
NUMBER
PAR36 R12-2L R18-2L R24-2L 12R24-2L 12R36-2L LAMP WATTAGE*
D.C.
VOLTS
5.4 5.4 5.4 9
9
6
6
6
12 12 Total D.C. Wattage for
Sustained Illumination
1.5 Hrs. 2 Hrs. 4 Hrs.
12
18
24
24
36
–
12 16 –
24 –
–
10
–
–
The smallest ceiling footprint
in the industry – only 5" in
diameter! Shown with PAR 36
Lighting Fixture.
*Note: Lamp type and/or wattage may be substituted to suit
specific application requirements. (Contact factory.)
OPTIONS
Item ADD SUFFIX:
Nickel Cadmium Batteries (6 V - 18 watts, 12 V - 36 watts) . .# – NI
Pure Lead Batteries (6 V - 18 watts, 12 V - 36 watts) .....# – LL
Wire Guard .............................................................#–WG
Time Delay for use with HID .......................................#–TD
Voltmeter ................................................................#–V
Ammeter ................................................................#–A
TECHNICAL DATA
Total Allowable Wiring Distance
Watts .....................#12 Wire ............ #10 Wire
25 . ............................ 85' ......................135'
50 . ............................ 42' .......................67'
100 . ........................... 21' .......................33'
INPUT ................... 120/277 VAC ......60 Hz - 5 Watts
Dimensions.: Back Box – 6" x 9" x 6.5" deep. Hanger Bars extend to 24"
ROUGH IN:
1. Mount the back box with the 24" hanger bars provided with the unit.
2. Remove the access panel in back box.
3. Connect the "Plug-in" pigtail wiring harness (with ground) to either a 120 or 277 VAC unswitched circuit.
4. Combination 1/2" – 3/4" knockouts provided for through wiring.
FINISH AND TRIM OUT:
1. Insert battery in back box through ceiling aperture.
2. Plug in electronics canister to battery & A.C. "pigtail".
3. Insert canister & push up until flush with ceiling.
4. Push test switch to verify system.
12 Volt Wire Runs for Remote Loads (6 Volt – Multiply Distance by .24)
Canister pulls down for easy
access and maintenance.
Completely serviceable from
below the ceiling.
All products are manufactured in accordance with U.L. Standard 924, and meet
or exceed requirements as established by the National Electrical Code Article 700
and Life Safety Code NFPA101. Specifications subject to change without notice.
EM6.0
CECLCD
Pathway Lighting Products, Inc., P.O. Box 591, Old Saybrook, CT 06475-0591
voice: 800.342.0592 • fax: 800.207.0090 • www.pathwaylighting.com • e-mail: sales@pathwaylighting.com