INSTALLATION INSTRUCTIONS
For VuLite V6RL3K-WH and V6RL3K-WH-T24
WARNING: For your safety, read and understand these instructions completely before starting installation. Before
installing this product, turn off electricity at fuse or circuit breaker box.
NOTE: VuLite products are designed to meet the latest NEC requirements and are listed in full compliance with
corresponding UL standards. Before attempting installation of any recessed lighting fixture or accessory, check your
local electrical building code. This code sets the wiring and installation requirements for your locality and should be
understood before starting work.
SAVE THESE INSTRUCTIONS
WARNING: Risk of fire or electric shock.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
• The electrical rating of this product is 120VAC. The installer must determine whether they have 120V at the
luminaire before installation.
• Luminaires wiring, ballasts, or other electrical parts may be damaged when drilling for installation of reflector kit
hardware. Check for enclosed wiring and components.
• Reflector kit installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt
installation. Contact a qualified electrician.
• Install this kit only in the luminaires that have the construction features and dimensions shown in the photographs
and/or drawings.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
VuLite V6RL3K-WH Retrofit LED
Trim Compatibility
The VuLite V6RL3K-WH LED trim is
designed to work with most standard
UL Listed 6” recessed incandescent
housings. Compatibility can be
determined by measuring the recessed
housing as follows:
A) Height: The housing must be at least
6-3/4” high
B) Diameter: The housing inside
diameter must be between 6”
and 6-3/4”
The recessed housing must also
contain brackets to support the trim
springs (see figure 1). If housing does
not contain spring retaining brackets,
contact factory to order an adapter kit.
Recessed
Housing
Typical Spring
Retaining Bracket
VuLite V6RL3K-WH-T24 LED
Downlight Module Compatibility:
The VuLite V6RL3K-WH-T24 contains
a connector that is designed to meet the
high efficacy requirements of California
Title 24-2008. The connector is only
intended to be plugged into the mating
connector in Juno housing part numbers
IC23-LEDT24 and IC23R-LEDT24. Use
of this module in other luminaires or
removing the factory installed connector
is not recommended and voids the
product warranty.
Dimming
The VuLite V6RL3K-WH and
V6RL3K-WH-T24 LED trims are
compatible with many dimmers designed
for incandescent or electronic low
voltage loads. Contact Juno Lighting
Group for a current list of compatible
dimmers.
Figure 1
Height
Diameter
1300 South Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • www.junolightinggroup.com
© 2011 Juno Lighting LLC
Rev 5/11
P2991
pg 1 of 2
INSTALLATION INSTRUCTIONS
For VuLite V6RL3K-WH and V6RL3K-WH-T24
Installation
CAUTION: Power to the luminaire must
be turned off prior to installing these
LED trims. Failure to do so can cause
electric shock, which can result in injury
or death.
Step 5. Insert trim torsion springs into
corresponding retaining brackets in
recessed housing. Carefully push trim
towards ceiling until the springs pull the
trim tight.
WARNING: This trim must be grounded
as outlined in this instruction sheet.
Failure to do so can result in electric
shock or undesired operation.
Step 6. Turn power back on to fixture.
Step 1. Confirm the LED trim is
compatible with the recessed housing
as outlined previously in these
instructions.
Ground
Terminal
Ground
Terminal
Connector
Ground Wire
Socket
Ground Wire
Torsion Spring
Step 2. (V6RL3K-WH only) Some
recessed housings contain an
adjustable plate or bracket that
supports the socket. The socket must
be detached from the plate/bracket,
and the plate/bracket must be removed
from the housing prior to installation of
the trim. For detailed instructions on
removing the plate or bracket, refer to
manufacturer’s installation instructions.
V6RL Trim
V6RL-T24 Trim
Figure 2
Remodel Style
Recessed Housing
Step 3. Screw the trim into the socket
in the recessed housing (V6RL3K-WH)
or connect the trim connector to the
housing connector (V6RL3K-WH-T24).
Ground Terminal
from Trim
Screw
Step 4. Securely attach the ground
wire terminal to any screw located in
the recessed housing that fastens
metallic components. Screws can
commonly be found near the base of
the recessed housing, where the socket
mounting bracket was installed, or in
the torsion spring bracket. If screws are
not present in the recessed housing,
contact a qualified electrician for
assistance in determining a suitable
ground. (see figures 3 & 4)
Figure 3
New
Construction
Recessed
Housing
Screw
Figure 4
Ground Terminal
from Trim
WARRANTY
Juno Lighting Group warrants that its products are free from defects in material and workmanship for three years from date of purchase. Juno
Lighting Group’s obligation is expressly limited to repair or replacement, without charge, at Juno Lighting Group’s factory after prior written
return authorization has been granted. This warranty shall not apply to products which have been altered or repaired outside of Juno Lighting
Group’s factory. This warranty is in lieu of all other warranties, expressed or implied, and without limiting the generality of the foregoing phrase,
excludes any implied warranty of merchantability. Also, there are no warranties which extend beyond the description of the product on the
company’s literature setting forth terms of sale.
Product Services Phone (888) 387-2212
1300 South Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • www.junolightinggroup.com
© 2011 Juno Lighting LLC
Rev 5/11
P2991
pg 2 of 2