Installation instructions - Chicago Plenum

advertisement
INSTALLATION INSTRUCTIONS
IC LED Housings - Air Tight - Chicago Plenum (optional)
TO BE USED IN INSULATED MATERIALS - SUITABLE FOR DAMP LOCATION
LEU-ICLDLD1, LEU-ICLDLD2, LEU-ICLDLE1, LEU-ICLDLE2
LEU-ICLDLD1P, LEU-ICLDLD2P, LEU-ICLDLE1P, LEU-ICLDLE2P
1.
SHUT OFF ELECTRICAL SUPPLY AT SOURCE.
2.
Remove the can from the « IC » box by unscrewing the two screws that hold it
in the box and reserve it with the screws for installation at STEP 10.
3.
Locate position of mounting frames and install before the gypsum board.
Fasten the mounting frame to the wood joist with the adjustable mounting
bars (10’’ to 24,5’’). To shorten the bars to 10’’, remove bars and cut off at
the knotch (See adjustable mounting bars detail view).
4.
Diagram 0-10V dimmer (D1 - D2)
Line (Black)
Once the correct bar length is known, fold down and press tabs to lock the plate
onto the mounting bars.
Neutral (White)
+10V Out (Yellow)
Light
Fixture
Ground (Green)
Dim + (Purple)
Dim - (Gray)
1.1.
1.
Joist
Mounting
Bar
7.
Install the ceiling material and locate the center of fixture.
8.
Cut a hole to a diameter of: Ø 3-5/8’’ (92 mm)
9.
Connect the housing wires to the can wires.
Press down
and fold tabs
Part 1
Adjustable bars detail
Cutting Mark
The sides are bridged to avoid separation after
shortening on «Cutting Mark».
Part 2
Cutting Mark
If Part 2 needs to be shortened, both Parts will
be held in place by «claws» on the IC Box.
5.
Bring the electrical wiring to the housing junction box as per applicable local
electrical codes.
6.
Open the junction box and connect the wires based on diagrams below.
Close the junction box.
Diagram ELV dimmer (E1 - E2)
10. Insert can in the housing and fix it with the two adjustment screws.
1 3/4" adjusting slot
to allow up to 1 1/2"
thickness of gypsum
board.
Screws
Spring
Adjustable
can
11. Install the trim.
Connect the male and
female connectors.
Push connected wires in the pot
then push the trim in the can.
Line
(E1 Brown / E2 Black)
Neutral
(E1 Blue / E2 White)
Light
Fixture
A) Male connector
B) Female connector
Ground (Green)
C) Trim
Please keep these installation instructions for future maintenance.
CAUTION The use of another company’s products or components
in conjunction with this product may not be covered by UL
approvals, and could be hazardous. Such use automatically
voids all warranties and responsibility for any problems that
may result from such use.
WARNING SHOCK AND FIRE HAZARD
Most dwellings built before 1985 have supply wires rated 60°C.
Consult a qualified electrician before installing.
Please visit the Website to see the list of compatible
dimmers or for more details.
AIR TIGHT
ASTM Test #E283
11 Mayfield Avenue Edison, NJ 08837
t 732.225.0010 f 732.225.0250
www.leucosusa.com
EL638 (Rev. C)
103714
2016-04
Download