AMD Technologies, Inc.
T 310.470.8900
W digitalams.com
218 Bronwood Avenue
T 800.423.3535
W ams4illuminators.com
Los Angeles, CA 90049-3104
F 310.471.8900
E info@digitalams.com
Drawings and
Specifications
PRODUCT:
SERIES:
MODEL(S):
Information Signs
“X-Ray in Use”, “Darkroom in Use”, “CT in Use”, “MRI in Use” or Custom Wording
900X, 900D, 900CT, 900MR, 900Custom
(Models with both incandescent and LED lamps–LED models have “-LED” model suffix)
(Models that are single or double sided-double sided models have “-DS” model suffix)
MOUNTING: Wall or ceiling mounted
Important Safeguards
 Read and follow all safety instructions.
 Do not mount near gas or electric breaker.
 Before wiring to power supply, turn off electricity at fuse or circuit
 Fixture must be grounded to avoid potential electric shock.
breaker.
 Equipment should be mounted in location and at heights where it will
 Disconnect AC power before servicing.
not readily be subjected to tampering by unauthorized personnel.
 All servicing should be performed by qualified personnel.
 The use of accessory equipment not recommended by the
manufacturer and may cause an unsafe condition.
 Consult your local building code for approved wiring and installation.
 Do not use this equipment for other than intended use.
 Do not use outdoors.
Housing




Material: Steel
Contruction: Bent and welded
Finish: Baked Enamel
Color: Off-white
Electrical

Power Input: 120 volt

Connection: Knockouts
Lighting

Two 15 watt incandescent lamps, or

Two 1 watt LED lamps
Dimensions

7 7/8” x 11 5/8” x 2 ½” (20 x 29.5 x 6.4 cm)
Shipping Weight

6 lbs (2.7 kgs)
Installation instructions:
1. This unit can be ceiling, end or wall mounted to 3-0 or 4-0 junction boxes.
2. Remove lampholder/reflector assembly from unit by pressing on front to disengage lances.
Ceiling/end mount
1. Remove center knockout from top for ceiling mount or remove knockout from desired end.
2. Fasten canopy to housing end/top with hex head chase nipple and lock nut.
3. Feed black and white luminaire leads through hex head chase nipple and canopy. Attach lampholder/reflector assembly to luminaire.
4. Attach end/ceiling mounting bar to junction box with supplied screws.
5. Attach ground lead from junction box to green ground screw and cup washer. Connect black lead from luminaire to black lead from junction box
and white lead from luminaire to white lead from junction box with wire nut (not supplied).
6. Fasten canopy to mounting bar with two screws.
7. Install lamps and face plate.
Wall mount
1. Remove large knockout in center of back plate and appropriate junction box knockouts.
2. Snap plastic bushing into center hole.
3. Feed black and white lampholder leads through plastic bushing. Connect black lead from luminaire to black lead from junction box and white
lead from luminaire to white lead from junction box with wire nut (not supplied). Feed ground lead from junction box through plastic bushing.
4. Fasten luminaire to junction box with two screws.
5. Connect ground wire from junction box to green ground screw and cup washer in ground screw knockout in back of luminaire housing.
6. Attach lampholder/reflector assembly to luminaire housing.
7. Install lamps and face plate.
Revision Date: 9/1/2015
Doc No. 330-3-507 rev. 01
Specifications subject to change without notice
Page 1