DITEK’s DTK-120GP Surge Protective Device (SPD)
protects critical gate motors, ensuring secure access to
guarded properties. It is designed for both indoor and
outdoor environments, and is installed at the protected
equipment.
Technical Specifications
Service Voltage:
120VAC
MCOV:
130VAC
All modes – L-G, L-N, N-G
Protection Modes:
Product Features
600V L-N
500V L-G
900V N-G
 Designed for installation on the terminals of a
120V single phase gate motor
Voltage Protection Rating:
 Approved for 20A circuit breakers
Surge Current Rating:
72,000 Amps
 NEMA 4X weatherproof enclosure
SCCR:
10,000 Amps
 Parallel connection for ease of installation
Nominal Discharge Current
Rating (In):
 Diagnostic LED provides positive indication of
power, ground presence, and surge protection
 Automatically resets to handle multiple surge
events
10kA
Operation Frequency:
50/60Hz
Mechanical Characteristics
¾” NPT threaded fitting
Connection Method:
Applications
Housing:
 Gate Motors
Operating Temperature:
NEMA 4X
-31°F - 185°F (-35°C - 85°C)
Maximum Humidity:
Dimensions:
95% non-condensing
2.83“L x 1.68“W x 2.93“H
(71.9mm x 42.7mm x 74.4 mm)
Weight:
.5 lb (227g)
Quality, Standards & Approval
Agency Approvals:
UL1449, cUL
SPD Type:
Type 2 SPD
Warranty:
Ten Year Limited Warranty
Every precaution has been taken to ensure that this literature is accurate and complete. DITEK Corporation assumes no responsibility and disclaims all liability for damages resulting from the use of this information or for any errors or omissions.
One DITEK Center 1720 Starkey Road - Largo, FL 33771
Phone: 1-800-753-2345 Direct: 727-812-5000
Technical Support: 1-888-472-6100
www.ditekcorp.com
Doc. Number: SPS-100024-003 Rev 4 04/15
©2015 DITEK Corp.
Page 1 of 1