EV-24V-1100-33D 24V 26W Dimmable CV DC LED Driver ETL (UL) approved Universal Input range from 100~120V AC, 50-60Hz, Pf> 0.95 Magnetic Dimmable DC Output: 24V, 1100mA (26.4W) Dimmable, Suitable for Leading Edge or Trailing Edge TRIAC dimmers Protection: Short-Circuit / Over Current / Over Voltage and Auto-recovery Mode Compact, lightweight plastic case. Lamps wired in parallel Double Isolation for Safety Terminal Screw Connection (Input: N, L. Output: +24V, GND) Approvals: ETL US (UL), CE, TUV, RoHS -20C to +45C, full load, max case 70C, 20 to 95% RH NC Size: 6.69” L x 1.89” W x 1.00” H (170mm L (not Inc. Screw tab) x 48mm W x 25mm H) 2 year warranty Note: All illuminous dimmable drivers will dim from 100% to 5%, This correlates to 24V down to 0V virtually. Each LED has a Vf (Forward Voltage), Typically is 3V, and when the driver dims below this voltage, it will simply stop working. So dimming performance is a factor of the LED, not the driver. Note: Dimming performance optimal at greater than 50% load. i.e. 6W+ for a 12W driver. So pick the right illuminous driver, 12W, 26W or 48W Vs2_2 040516 EV-24V-1100-33D 24V 26W Dimmable CV DC LED Driver ETL (UL) approved Compatible Dimmers All Illuminous dimmable drivers will dim from 100% to 5%. Each LED has a Vf (Forward Voltage), typically is 3V, and when the driver dims below this voltage, it will simply stop working. So dimming performance is a factor of the LED, not the driver. Dimming performance is optimal at greater than 50% load. So pick the right Illuminous driver, 12W, 26W or 48W Best Dimmers are 'Incandescent ONLY' i.e. Leviton 6631, followed by 'Incandescent / Halogen'. Avoid 'Universal' unless Load is matched to Driver Capacity, i.e. avoid large driver with small load Note, The below dimmers have been tested to work, but dim performance is dictated by: a) The type of Dimmer (Incandescent ONLY, or Inc / Hal, or Universal (Inc, Hal, CFL, & LED) b) The Ratio of Load size to Dimmer max capacity. Best dimming is 50% to 80% Load. Brand Lutron LEVITON INSTEON REV BUSCH EVERFLOURISH JUNG ROB TCL CLIPSAL PEHA LEGRAND MASANO BE LICHTREGLER BERKER Vs2_2 040516 Part No SKYLARK:S-600,S600P,SF-10P,SF-12P-277, MACL- 153-M (Maestro), LGCL-153PH (Lumea), LG600H (Lumea), DV-600P (Diva), CREDENZA TT300, DVF-103P-277 6615-P, 6633-P, IPL06, 6672, 6631 – Best Overall Insteon 2477D SwitchLinc (Remote Control) DualBand Dimmer (Note:2477S does NOT work) 136231 6513 U-102 EF700DC 225 NV DE, 225TMD, 243EX, 244EX L2503G2W A6,M2 E3032HD, 32E450UDM, 32E450TM 434 A8051 A6B11 T39.01, T46 Tronic-Dreh Dimmer286710 Dimmer type Leading Country USA Leading Leading USA USA Leading Trailing Trailing Leading Leading Leading Trailing Leading Leading Trailing GERMANY EUROPE GERMANY EUROPE LRELAND CHINA AUSTRALIA GERMANY FRANCE AUSTRALIA KOREA GERMANY Conclusions for Flex Strip (Direct LED driving): W/ft varies by length due to Strip Resistance. 16.3ft = 2.6W, 8.2ft = 4.2W, 4.1ft = 4.8W, 2.0ft = 5.5W, Best Overall Dimmer is Leviton 6631, Dimming to 25% or better even with poor Load / rated Max. Improves to sub 10% dim with >50% Load / rated Max Most 'standard' Incandescent / Halogen dimmers preform well (down to sub 25% Dim) if the load > 70% of rated max, and OK (down to 30% Dim) if >60% Load In General 16.4ft to 8ft use 48W driver, 8ft to 4ft use 26W, sub 4ft use 12W Conclusion for MR16 & 12W Driver Leviton 6631 Best dimming Lutron DV-600PR, Insteon 2477D, Lutron LG-600 very good dimming Above Dimmers not affected by a low load as 5W on a 12W driver, i.e only 42% load. Higher Load would improve dimming level. Vs2_2 040516