Exhibitor Services
Ordering 208 Volt through
480 Volt Power
Equipment Requiring 208-Volt Power
Equipment requiring high voltage power will range from heavy machinery and
medical devices to industrial cooking equipment. Most industrial equipment is rated
at 208 volts, but other typical voltages include 220, 230 & 480 volt.
The ratings placed on the equipment will indicate VOLTAGE, AMPERAGE and
PHASING. All three ratings are required to order the correct service.
Example rating stamp for Industrial Pizza Oven
208V 60A 3Ph
This rating indicates the equipment runs on 60 amps of 208-volt three-phase power.
Example rating stamp for Technical Medical Equipment
220V 20A 1Ph
This rating indicates the equipment runs on 20 amps of 220-volt single-phase
power.
EDLEN ELECTRICAL EXHIBITION SERVICES
CORPORATE INFORMATIONAL RELEASE
Exhibitor Services
Make sure to order a separate outlet for each piece of equipment. Each piece of
equipment requires a separate outlet.
Equipment Requiring 220 to 240 Volt Power
If your equipment requires a higher voltage such as 220 or 230 volt, place your
order as follows:
1. Using the 208-volt single phase or three phase sections of the order form,
complete the quantity field and total cost column.
2. Write in the actual voltage requirement in the blank area next to the outlet
ordered.
3. Just below the 208 volt three phase section of our order form there is an area
that allows you to order a transformer to boost your power from 208-volt to
approximately 220 or 230 volt. Multiply your amperage ordered by the "per amp"
charged noted on the order form. Please note, there is a minimum 20-amp
charge.
Always check with one of your technicians before placing your order for 220-volt or
230-volt power. You may find that your equipment can run temporarily on 208-volt
power, thus eliminating the need for a transformer.
Equipment Requiring 380 to 480 Volt Power
If you equipment requires 380 volt thru 480 volt power and those services are not
listed on the order form, please contact the phone number provided on our order
form or call 800-553-3536 for more information. The cost of 480 volt services is
available if ordered on-line. Exhibitors requiring 380 Volt power must contact the
Edlen office producing the event for additional order information.
EDLEN ELECTRICAL EXHIBITION SERVICES
CORPORATE INFORMATIONAL RELEASE