ACCESSOIRE PRESSURE SWITCHES This type of pressure switch features a high degree of miniaturisation and a modern attractive design. It can be installed in any position and also mounted onto a wall by means of two transversal holes. In order to reduce wiring times, it is supplied ready assembled with a 2-metre electric cable or an M8 connector with a 300-mm cable. The contact is the switching type, which means it can be normally open or normally closed. A knurled push-lock handle is provided for regulation TECHNICAL DATA Adjustable pressure interval Hysteresis (not adjustable) Maximum pressure Operating temperature range at: 1 MPa; 10 bar; 145 psi Lower threaded port Maximum current Maximum voltage Outside diameter of cable Number of wires and cross section Contacts Protection Number of switchings Fluid Mounting position Weight bar bar bar MPa psi °C °F A V mm Kg 0.5 ÷ 10 from 0.4 to 0.8 (See diagram) 15 1.5 217 50 122 R 1/8” 2 250 4.9 3x0.5 mm2 Normally-Open (NO) and Normally-Closed (NC) IP65 5x106 Filtered lubricated or unlubricated compressed air. Lubrication, if used, must be continuous In any position 0.121 COMPONENTS Technopolymer adjusting push-lock handle Brass adjusting screw Steel piston spring Brass piston NBR gasket Body made of anodized aluminium Technopolymer pressure switch body Resin finish for IP65 Electrical contact Choke to reduce peaks in pressure 1 2 8 3 9 7 4 6 5 10 3.1/74 WIRING DIAGRAM DIMENSIONS BLACK NC BROWN 57 ø4.9 VERSION WITH CABLE BLUE foro x M3 20.5 R 1/8 VERSION WITH M8 CONNECTOR 13.4 16 24 29.2 M8 4 1 ~300 mm HYSTERESIS GRAPH psi bar 140 10 130 9 NO ~2 m 3 1 - 3 NO 1 - 4 NC ORDERING CODES Code 9000401 9000402 Description ACC. - 1/8 2A NO/NC PRESSURE SWITCH, 2-METRE CABLE ACC. - 1/8 2A NO/NC PRESSURE SWITCH, M8 CONNECTOR 120 High switching pressure 110 100 90 80 8 3 7 6 70 5 60 4 50 40 3 30 2 20 10 0 1 0 0 1 2 3 4 5 6 7 8 9 10 0 10 20 30 40 50 60 70 80 90 100110120130140 bar psi Low switching pressure ACCESSORIES SECURITY KNOB Code 9200703 NOTES Description ACC. SECURITY KNOB NOTE: Pull outwards to remove the knob from the pressure switch on the unit. Insert the security knob and regulate the pressure switch. Then press the handle firmly to lock it in position. If the pressure switch needs to be reset, remove the security knob by forcing it laterally with a screwdriver. 3.1/75