CMT6107HR PC/104 IDE Drive Peripheral Modules with Floppy Interface Operating Temperature -40° to +85°C IDE Connector Module Versions: Configuration External Port Part Number Drive Type IDE Port Floppy Port CMT106ER TBD - - - - - TBD 1 1 - 1 1 CMT6106HR CMT107ER CMT6107HR Jumpers Floppy Connector ISA (PC104) Features: CMT6107HR with Floppy Interface Peripheral Module Available as a ruggedized IDAN® module IDAN-CMT6107HRS with external Floppy IDAN-CMT6107HRD with external Floppy and IDE Rugged IDAN® Configuration Provides a compact IDE drive directly in your (Single height frame shown with Floppy connector) PC/104 stack Dual height frame available with Floppy and IDE Decodes the IDE interface from the PC/104 bus or through connector Requires no additional IDE controller on cpuModule™ or VGA module Protects drive against power supply reverse-polarity, over-current, and over-voltage Slave IDE drive connector Dual Floppy controller Supports: IDE ATA series 2.5" rotating drives IDE ATA series 2.5" Flash drives Description: Easily add a compact drive to an embedded PC/104 stack with our CMT107ER and CMT6107HR Peripheral Modules. The CMT6107HR provide a 2.5" IDE drive and floppy interfaces through the PC/104 bus. Protection components reduce the possibility of drive damage due to reversed power-supply polarity, over-current, or over-voltage. Physical Attributes:(without drive installed) Size: 112mm L x 96mm W x 15mm H (4.4"L x 3.8"W x 0.6"H) Weight: Approximately 0.07 Kg (0.16 lbs.) Operating Temperature: -40° to +85°C: 90% humidity non-condensing Storage Temperature: -55° to +125°C Power requirements 0.4 W (+drive current) @ 5 VDC typical systerra computer GmbH | Kreuzberger Ring 22 · D-65205 Wiesbaden | Tel: 0611 9748 470