1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
© 2011 Edge Lighting. All Rights Reserved.
Installation Instructions for
MAR-RD-22-_-CH
904-MARILYN-01
MAR-SQ-24-_-CH
Marilyn Round & Square
IMPORTANT INFORMATION
- This product is wall mounted only.
- This instruction shows a typical installation
- This Fluorescent lamps are not dimmable.
SAVE THESE INSTRUCTIONS!
Install the Backplate
A
1: Remove the two Phillips screws from the sides of the
backplate.
1
BACKPLATE
2: Carefully remove the mirror.
B
THREADED STUD
BACKPLATE
MIRROR
PHILLIPS SCREW
1
SOCKET
ASSEMBLY
3
THUMB
NUT
3
3: Remove the thumb nuts, and carefully remove the socket
assembly.
1
C
BACKPLATE
NOTE: It is recommended that one person holds the backplate
while the electrician installs it.
4: Align the backplate center hole with the electrical box. Level
the backplate horizontally and mark the four key holes onto
the wall.
5: Remove the backplate.
MOUNTING PLATE
CENTER HOLE
ELECTRICAL
BOX
4
D
WALL
6
6: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
7
ANCHOR
7: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
8: Tighten (not completely) the four #8 screws into the anchors
leaving the head unscrewed for 1/8".
E
PHILLIPS SCREW
8
F
PHILLIPS SCREW
BACKPLATE
11
9
9: Feed the power wires coming from the electrical box
through the backplate center hole.
10: Hang the backplate keyholes onto the exposed screws.
10
11: Tighten the four #8 screws completely to the secure the
backplate in place.
2
G
12: Make sure that the backplate is grounded in accordance
with local electrical codes.
13: Connect the white socket assembly wire to neutral power
wire a wire nut.
14: Connect the black socket assembly wire to the hot power
wire with a wire nut.
14
H
13
BACKPLATE
THUMB
NUT
12
16
15
SOCKET
ASSEMBLY
16
15: Place all wires inside the electrical box and socket
assembly.
THREADED
STUD
16: Mount the socket assembly to the backplate threaded studs
with the thumb nuts.
Install the Lamp & Mirror
I
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
BACKPLATE
Use MAX 20 Watt Type E12 Candelabra base
Krypton/Xenon For Each Socket.
1
Use MAX 18 Watt Type E12 Candelabra base
Self Ballast Compact Fluorescent Spiral Lamp For
Each Socket.
1: Screw the lamps completely into the sockets.
J
BACKPLATE
2
MIRROR
SOCKET
ASSEMBLY
2: Align the mirror brackets to the backplate brackets. Place the
mirror into the backplate and tighten the Phillips screws to
secure the mirror in place.
PHILLIPS SCREW
2
3