INSTRUCTIONS FOR USE OF YOUR SOFT COMB QUILTED HAMMOCK & STAND SET
This Carton Contains:
A. 1 Soft Comb Quilted Hammock with Link chains & S hooks attached.
B. 1 Hammock Frame
1. 2 Foot Brackets
2. 2 Straight beams with end cap.
3. 1 Straight beam without end cap.
Assembly Instruction (No tools required):
Push down the spring pins on the foot brackets while pushing the poles in place until the pin exits through the hole and locks in
place.
1. Insert Straight beam without end cap between the two foot brackets.
2. Insert the remaining two poles on the other end of the foot brackets facing upward. Make sure the end with the end cap is
at the top and facing inwards toward each other.
3. Insert S-hook into the hole provided in the beam. Repeat it at the other end as well.
4. Place one chain on the hammock over the S-hook at one end of the frame.
5. Hook the other chain on the S-hook at the other end. It may help to stand behind the stand and pull toward you.
6. Take extreme care when entering the hammock for the first time. If the hammock goes to the ground, exit the hammock
and tighten up the chain. You may now carefully enter the hammock. Repeat this until you find a comfortable height.
NATURAL DEFECTS OF WEATHERING FROM SUN AND RAIN EXPOSURE:
All hammocks deteriorate over time with exposure to the elements. As a result, they should be regularly inspected and replaced
periodically to ensure safety.
Rope:
Fibers will darken to a gray color, as fiber breakdown, strength will be lost. If not allowed to dry thoroughly, mold or mildew will
result.
Wood:
Wood spreader bars on hammock will become bleached and may turn gray. Varnishing finish may wear off surface.
Fabric:
• Polyester fabric makes this product easy to clean.
• Simply wash the cushion with a soapy solution of liquid dish washing detergent and warm water.
• Rinse thoroughly with clean water to remove soap before air drying.
Important Information:
When you open your hammock, it may have become distorted or have gaps in the bed due to packaging. Do not be alarmed, this
is normal. Hang the hammock up and simply brush your hands across the weave to straighten it out. Due to a built in stretch
factor, you may have to adjust the tension in the hammock several times. It will stretch to its desired length after continued use.
Precautionary measures:
• Check for loose or untied ropes.
• Fraying at possible wear points.
o Where the ropes pass through the wooden spreader bar.
o Around the metal ring at each end of the hammock.
o Where the ropes intersect in the body/hammock bed.
• Weak and fraying ropes: Check ropes by pulling on them. If ropes are weak, the hammock may be unsafe for further use.
• Cracks or weak areas in the wood.
• Keep hammock out of direct sunlight and rain whenever possible.
• Make sure your stand is properly assembled using these instructions before attaching hammock to stand. Check the
assembly of the frame prior to each use. Make sure the larger pole fits all the way over the small pole before each use.
These precautionary measures are especially important before hanging your hammock each season and before storing it away.
Warnings:
o Maximum weight capacity is 275 lbs. NEVER exceed weight capacity.
o Children should not use the hammock without adult supervision.
o Always inspect the hammock and ties carefully before each use.
o Examine the entire hammock for wear to avoid accidents.
o Hammocks are designed for leisure and relaxation. It should not be used as a toy or swing. Do not stand in the hammock
at any time.
o Your hammock is made of the highest quality polyester fabric. Your hammock’s worst enemies are rain, sun and heat.
To prolong the life of your hammock, store it in a safe dry place when not in use. You may also choose to purchase a
hammock storage bag, cleaner and protective shield to prolong the life of your hammock.
o Please check for excessive rust and twist in the hanging hardware before and periodically during the usage season.
For any queries, call our customer service at 877-494-4954, 9 a.m. – 5 p.m., Monday-Friday (or) mail us at
customercare@deepaindia.com
Assembly Instructions - Hammock combo
Step - 1
Make sure all parts of the hammock set are present
as above
Step - 3
Insert the centre pole (without end cap) to the foot bracket
Step - 5
Fix the straight beam (with end cap) to one end of the
foot bracket as shown above
Step - 7
Check & make sure the hammock contains 'S' hook at its ends
Step - 2
Place the 2 Foot brackets at an appropriate distance
Step - 4
Insert the other end of the straight beam to the
other foot bracket
Step - 6
Make sure the other beam is affixed the same way
Step - 8
Insert S hook into the hole at one end and fix the link
chain to it. Repeat it at the other end too.
Important Technical Instructions to insert Spring pins
Step - 1
By default, spring pins are found on the foot bracket
Step - 3
Make sure the pin exits through the hole and locks
in place
Step - 5
Push down the spring pins on the foot bracket
while pushing the beam into its place
Step - 2
Push down the spring pins on the foot bracket
while pushing the beam into its place
Step - 4
Beam with end cap is assembled the same way
Step - 6
Make sure the pin exits through the hole and locks
in place