www.clarksol.com
MG200 Gear Pump with Brushless DC Motor
0 to 210 LPH, Pressure to 5 bar
DESCRIPTION
The MG200 Series magnet drive gear pumps are compact precision
performance products for high technology applications. The magnet drive
principle provides a totally sealed pump chamber that is capable of
handling a wide range of corrosive liquids with a high degree of safety.
The housing of the pump and the internal metal parts are AISI 316 stainless steel. The gears are available in PTFE or PEEK.
In operation the MG 200 Series pumps are noiseless, pulsation-free and
capable of handling relatively hot liquids i.e. 120°C (248°F) at a low
coefficient of expansion. The principle of the magnet drive comprises an
inner PEEK encapsulated magnet embodied in the pump, connected to
the driving gear and an outer magnet connected to the motor shaft. The
pole-to-pole alignment of the magnets provides the driving motion to the
pump. Decoupling occurs when the pump load exceeds the coupling
torque between the magnets.
In/out ports have 1/8'' NPT female threads. A built-in relief valve is available upon request. The unit is supplied with 24 Volt brushless DC motor
and Variotronic speed control system.
MG Gear Pump Shown With Motor & Drive
TYPICAL APPLICATIONS
· Medical equipment & Lab instruments
· Lubrication
· Sampling
· Cooling systems & Lasers
· Ink-jet printing systems
DIMENSIONS (MM)
MGBR1 (Motor Assembly)
Nom. Voltage
24 VDC
Voltage Range
10-30 VDC
Nom. Speed
6000 RPM
Nom. Torque
56 mNm
Nom. Current
2.8 A
Nom. Output Power
35 W
The VT1401 Variotronic is a compact electronic drive for operating brushless, electrically commutated direct current motors.
Speed is set via a command voltage of
0-10 V. A speed controller compares the
command voltage with the actual speed
value and preset PI control settings adjust
the motor speed.
Note: See our Model FG, for a gear pump with integrated brushless DC
motor and controller.
ORDERING INFORMATION
1) Order motor assembly separately- (MGBR1)
2) Order optional Variatronic controller- (VT1401)
3) Build Pump Part Number From Table- (MG209XP017)
Model
MG 2
Gear Width
Housing Gear/Bushing ReliefValve Connections
04=4mm
X=Stainless
P=PEEK
1=Yes
17= 1/8” NPT
09=9mm
Steel(316)
T=PTFE
0=No
Threaded in-line
13=13mm
Clark Solutions 10 Brent Drive
Hudson, MA 01749
Tel. 978 / 568 3400
Fax 978 / 568 0060