Encoders
Dynapar ™ b r a n d
Pivot Mounting Bracket
• Complete pre-assembled mounting system with
hardware included
• Single or dual wheel uses same mount
• Easy machine attachment
• Built-in spring tension for accurate tracking
APPLICATION/INDUSTRY
SPECIFICATIONS
Provides adjustable, vertical, spring loading
for the listed "Compatible Encoders" equipped
with measuring wheels.
COMPATIBLE ENCODERS
The mounting bracket may be used with the listed series
encoders having the specified mounting configurations.
DESCRIPTION
Rugged and stable, the bracket is precision
machined from heavy gauge aluminum.
Encoder is mounted using holes which are
positioned to accommodate the listed
"Compatible Encoders". Dual shaft encoders
may accommodate two wheels.
Encoder Series
60A
60C
H42
H25
H25
HA725
Clearance holes are provided for base
mounting to a suitable surface, or it may be
mounted to 2" diameter tubing through use of
"U" clamps.
I
N
C
R
E
M
E
N
T
A
L
Encoder and
measuring wheels
not included
A
C
C
E
S
S
O
R
I
E
S
Mounting Configuration
All
All
2.5" Flange
2.5" Flange
2.5" Servo
2.5" Flange
Figure
2
1
3
3
4
3
Ordering Information
Model No.
14005740000
Description
Pivot Mounting Base
Dimensions
7.75"
Allow 7.000" to clear
Connector and Cable
May be mounted to 2" O.D.
Tube using (2) standard
automotive "U" clamps
11/32" (0.343) Dia.
Thru (4) Holes
4.25"
2.44"
1.97" (Ref.)
0.38"
3/8" NOMINAL **
MATERIAL FLOW
2.
128
** SETTING OF 3/8" ALLOWS PROPER TRACKING PRESSURE
REAR VIEW
MTG. DIMENSIONS
0.75"
CL
1.25"
2.50"
4.00" (Ref.)
Encoders
INSTALLATION
Figure 1
Figure 2
Figure 3
Procedure
Procedure
Procedure
60C Series (Dual Wheel)
Face Mount Installation
1) Mount encoder pilot in
recess of "L" bracket.
60A Series (single Wheel)
Face Mount Installation
1) Mount encoder pilot in
recess of "L" bracket.
2) Align (3) holes in face of
encoder with counter-bored
holes in bracket. Secure with
#5-40 x 3/8" pan head
machine screws with #6 split
lock washers (included).
2) Align (3) holes in face of
encoder with counter-bored
holes in bracket. Secure with
#5-40 x 3/8" pan head
machine screws with #6 split
lock washers (included).
H25 & H42 Series (single
Wheel) Flange Mount
Installation
1) Mount encoder pilot in
hole of "L" bracket.
3) Install measuring wheels
with hub side flush with shaft
end and set screw over flat
on shaft. Tighten set screws.
3) Install measuring wheel
with hub side out and position center line at dimension
shown above. Tighten set
screws.
2) Align (4) holes in face of
encoder with counter-bored
holes in bracket. Secure with
#10-32 x 1/2" pan head
machine screws with #10
split lock washers (included).
I
N
C
R
E
M
E
N
T
A
L
A
C
C
E
S
S
O
R
I
E
S
3) Install measuring wheel
with hub side out and position center line at dimension
shown above. Tighten set
screws.
2.
129