Assembly Instructions
Cetra®
Page 1 of 1
Jumper Cable
Tools Required
I
Figure B
10-Wire Jumper Cable
None
Description
Jumper cables are used to pass power from panel to panel at the
base or mid-wireway, and from base to mid-wireway within a
single panel (Figure C–Model Number Reference).
Note: Installation must be in accordance with the National
Electrical Code and local codes. Electrically interconnected panels
need to be mechanically connected.
Arrow
Nubs
AED
Installation
1. Position the jumper cable correctly according to the arrow
on the cable (Figures A & B).
2. Slide the jumper cable into the end of the power distribution assembly (AED) until fully engaged (Figures A & B).
Note: When fully engaged, the nub(s) on the jumper cable
should be grasped by the metal clip(s) on the power
distribution assembly.
Metal clips
Figure C—Model Number Reference
AEJ2
AEJ5
Non-Powered
AEJ5
18'W
AEJ7
Non-Powered
Non-Powered
AEJ2
120°
Model
Arrow
AED
Nub
Metal clip
135°
Application
AEJ1
Panel-to-panel
AEJ2
90° corner
AEJ3
120° corner
AEJ4
135° corner
AEJ5
Panel-to-post-to-panel
AEJ7
Mid-wireway X connector
AET2
Base-to-mid wireway
AET3
Through curved panel
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Mid-wireway X
F 812.482.8300
AEJ4
T 800.482.1818
AEJ3
Printed in U.S.A. © 2008 Kimball International, Inc.
Figure A
8-Wire Jumper Cable
Part No. 1699167 Revision C-08
AEJ2