Oris LED Sconce
Installation Instructions
General Product information
This product is suitable for indoor dry locations only.
This product can be dimmed with most standard dimmers.
Please see “Dimmer Compatibility” section of these
instructions for more information.
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read
all instructions and TURN POWER OFF TO THE
JUNCTION BOX
Installing the
Mounting Plate
1 Attach the mounting plate
to the junction box using the
supplied #8-32 screws. Orient
and level the plate as shown in
the figure.
1
8-32 Screw
2 Attach a suitable ground wire
to the green screw in the
mounting plate
Typical 3” Plaster Ring
2
Mounting Plate
Ground
Attaching the Back Plate
3 Connect the white fixture wire to the neutral power
7
line with a wire nut.
6
5
8-32 Screw
4
Back Plate
3
White (NEUTRAL)
4 Connect the black fixture wire to the hot power line
with a wire nut.
5 Place all wires in the junction box.
6 Mount the back plate to the mounting plate using
the supplied #8-32 screws.
Black (HOT)
7
CERNOGROUP.COM
T_949.715.1534
If necessary, use the additional holes in the back
plate to secure it to the wall.
2139 1/2 LAGUNA CANYON RD. LAGUNA BEACH CA 92651
COPYRIGHT 2012 CERNO LLC.
Oris LED Sconce
Installation Instructions
Attaching the Shade
8
Slide the shade over the back plate so that it hangs on the tabs.
9
Tighten the locking screw behind the diffuser until it presses against the
bottom edge of the back plate.
Tabs
8
9
Locking Screw
Dimmer Compatibility
The LED driver included with this fixture is designed to operate with most standard dimmers. Extensive testing with the dimmers listed below
has been conducted. This list of dimmers does not imply any guarantee or warranty of compatibility with a particular application. The lack of
dimmers on this list does not imply it is not compatible. All power ratings and installation instructions from dimmer manufacturers’ instruction
sheets must be followed.
Cooper, Aspire Series (Part numbers 9530XXX)
Leviton, Illumitech Series (Part numbers IPI06-XXX)
Leviton, Trimatron Series (Part numbers 6602-X, 6681-X, 6683-X, 6684-X, 700-X and 705-X)
Leviton, SureSlide Series (Part Numbers 6631)
Leviton, True Touch Series (Part Number 6606-1LM)
Lutron Skylark Series (Part Number S-600, S2-LH)
In addition, the following Electronic Low Voltage (ELV) dimmers that employ reverse phase control have been tested:
Lutron Maestro (Part Number MAELV-600
Lutron Nova T Series (Part Number NTELV-600)
Lutron Faedra (Part Number FAELV-500-XX)
Leviton Acenti (Part Number ACE06-XXX)
Leviton Vizia (Part Number VZE04)
CERNOGROUP.COM
T_949.715.1534
2139 1/2 LAGUNA CANYON RD. LAGUNA BEACH CA 92651
COPYRIGHT 2012 CERNO LLC.