K-DSC
DSC Power Series and Maxsys Intrusion Panel Integration (System VII software module)
*
• Observe and control your entire access and intrusion systems through one integrated software package.
• Add, delete, and modify individual’s DSC passcodes*, all through System VII.
• Active logging of all DSC panel activity, arming, disarming, alarm conditions and much more.
• Run reports on the entire building system, including all access activity and DSC panel activity.
• Provides real-time display of DSC system, zone and partition status.
• Present 3 defined readers provide control of system or partition arming and disarming based on user defined
permissions enforced by the System VII software.
• Generates email notification if a user defined DSC event is triggered. This ensures that management is the first to know
of a system breach of any kind. • Map DSC partitions on the Keyscan Active Map for true real-time system
wide ‘at a glance’ monitoring. * Power series only
www.keyscan.ca
K-DSC
DSC Power Series and Maxsys Intrusion Panel Integration (System VII software module)
FEAT U R E S A N D B E N E F I T S
• User gains control of their DSC intrusion panel by permitting administrators to quickly update employee pins.*
• Monitoring the entire building system from access control to intrusion all from one software package provides unprecedented
versatility and convenience.
• Comprehensive DSC event recording within the Keyscan database allows for in-depth user defined report generation provides
the necessary information to solve any access control or intrusion related investigation.
* Power series only
APP L I C AT I O N
KEYSCAN ALARM INTEGRATION
DSC PC4401 for Maxsys integration
DSC IT-100 for Power Series Integration
SPEC I F I C AT IO N S
DSC IT-100 / PC4401
(available through your DSC hardware supplier)
Powered via DSC Keybus
Keyscan Panel Requirements:
Panel(s) Hardware: Control Board Revision 11 or higher
Panel(s) Firmware: System EPROM 7.70/8.50 or higher
Connectivity to Keyscan RS232
TCP/IP with NETCOM2 (optional) *
Required Software Module: K-DSC
*See NETCOM2 for wiring and power supply requirements
KEYSCAN INC.
901 Burns Street East, Whitby, Ontario L1N 6A6
**Important Note: The K-DSC software module requires the
DSC IT-100 for Power Series integration or the PC4401 for Maxsys integration. Keyscan panels must meet minimum hardware and firmware requirements. Please consult the K-DSC Setup Guide for further configuration details.
Keyscan Inc. reserves the right to
alter designs and specifications
without notice or obligation
Phone: 905.430.7226 Toll Free: 1.888.539.7226 Fax: 905.430.7275
www.keyscan.ca
Rev.:09-2010