Base
Base
Gland plate with sealing bar
for TS, CM, TP
Can be installed in:
● TS in depth and width
● CM, TP in width
Reduces the base opening by 200 mm.
For example, a gland plate with sealing bar for
large supply cables can be mounted at the side in
the enclosure depth with the usual partition in the
width (200 mm smaller than the enclosure width)
adjacent to it, above the standard gland plates.
For
enclosure
width/depth
mm
For
module plates,
divided
Packs
of
Model No.
CM
500
2
1
5001.230
600
2
1
5001.231
800
3
1
5001.232
Accessories:
CM gland plate,
see page 911.
Section for cable entry, rear,
see page 1047.
Section for cable entry, centre,
see page 1046.
EMC gland plate,
see page 1032.
Cable glands,
see page 1054.
Material:
Sheet steel
Surface finish:
Zinc-plated, passivated
Protection category:
IP 55 to EN 60 529/09.2000
Supply includes:
Assembly parts and seals.
Also required:
Module plates,
see page 923.
Module plates, divided,
see page 924.
TS ordering example:
W 800 x D 600 mm
For 600 mm enclosure depth:
7 Gland plate with sealing bar CM 5001.231
5 Module plate, divided with grommet
6 Module plate, divided with 16- or 24-pole
cut-outs
For reducing the enclosure width by 200 mm
down to 600 mm:
5
6
2 Section for cable entry, centre
3 CM gland plate, depth 150 mm
2
7
4 CM gland plate, depth 250 mm
3
4
CM ordering example:
W 800 x D 400 mm
For 800 mm enclosure width:
7 Gland plate with sealing bar CM 5001.232
5 Module plate, divided with grommet
6 Module plate, divided with 16- or 24-pole
Base
cut-outs
1 CM gland plate, depth 50 mm
5
5
6
7
1
B
7.1
Clips
for gland plates
As replacement and for additional gland plate
attachments in TS, CM, TP.
Packs of
Model No. TS
50
8800.075
Material:
Sheet steel
Surface finish:
Zinc-plated, passivated
912
Rittal Catalogue 32/System accessories
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com