Dual Maintained Contact Data Input Module Description The Dual Maintained Contact Data Input Module provides sensing of dry contact closure from a third party device. The module allows third party devices to trigger events in the Savant System. The module has sixteen inputs and is powered from the Savant keypad bus. The Dual Maintained Contact Data Input Module works similar to a keypad. Closing the contact results in a press message, and opening the contact results in a release message. The difference between momentary and maintained is, the maintained contact module generates a press message and a release message when the connection state changes. No hold message is ever sent. All of this messaging is sent using the Savant keypad bus. Feature Summary • Provides sensing of maintained dry contact closure from third party device • Allows third party devices to trigger events Ordering Information LMI-MAI2 Dual Maintained Contact Data Input Modules are used when the customer wants any of the following: • • • • • Dual Maintained Contact Data Input Module Dry contact inputs Motion sensors Door contacts Any device that is a dry contact A custom layout of buttons Dual Maintained Contact Data Input Module 1 of 3 103012 009-0701-01 Document based upon target specifications. Specifications subject to change prior to final product release. Dual Maintained Contact Data Input Module Specifications Environmental Temperature 32° to 95° F (0° to 35° C) - Ambient Operating Humidity 10% to 80% Relative Humidity (non-condensing) Efficiency Over 99% at full rated load Dimensions Height 7.63 in/19.38 cm Width 10.25 in/26.04 cm Depth 3.0 in/32.88 cm Power 16 - 24V DC (Control Keypad Line) Non-backlit Keypads @10 mA nominal (no LEDs lit) @100 mA nominal (all LEDs lit) 16 - 24V DC (Control Keypad Line) Backlit Keypads @10 mA nominal (no LEDs lit) @200 mA nominal (all LEDs lit) Supply Voltage 16 - 24V DC Number of Inputs 16 Voltage Out 15V DC for relay contact interfacing Input 16 - 32V DC 5V DC/0.2 mA Analog Input Drive Requirements 12V DC/3 mA 24V DC/9 mA 2 of 3 103012 009-0701-01 Document based upon target specifications. Specifications subject to change prior to final product release. Dual Maintained Contact Data Input Module Wiring The next figure shows wiring connectors that provide maintained contact from one of the dry contact closures. Both dry contact closures have the same functionality. The next figure shows the logic level of one of the dry contact closures. Copyright © 2012 Savant Systems, LLC. SAVANT and RacePoint Blueprint are trademarks of Savant Systems, LLC. All brand names, product names and trademarks are the property of their respective owners. Savant Systems, LLC reserves the right to change product specifications without notice. 3 of 3 103012 009-0701-01