
Enable-IT 375 Gigabit
Power over Ethernet Injector
Quick Start Guide
All Rights Reserved 1997 - 2015 ENABLE-IT - Proprietary and Confidential

INSTALLING THE ENABLE-IT 375 GIGABIT POWER OVER
ETHERNET INJECTOR
The Enable-IT™ 375 75W - 56VDC Power over Ethernet Plus Injector is a single port
IEEE 802.3AT compliant Midspan solution that is compact and easy to install with RJ-45
Ethernet cabling. This elegant unit is ideal for installing any WiFi Wireless Access Point,
security camera or other PoE powered equipment. It eliminates the need for an external
power supply and its associated AC/DC power cabling, providing a compact, affordable,
safe and reliable power solution over your wiring or existing Ethernet infrastructure.
Unpacking the Enable-IT 375 Gigabit Power over Ethernet Plus Injector
Carefully remove the Enable-IT 375 Gigabit Power over Ethernet Plus Injector from all
packing materials in the box. Verify that the items listed below are present. Make sure that
the equipment supplied matches what you ordered. If any items are missing or damaged,
please contact your Enable-IT or your distributor for assistance.

(1) The Enable-IT 375 Gigabit Power over Ethernet Plus Injector

(1) US Type B 120VAC power cord

Enable-IT 375 Gigabit Power Over Ethernet Injector User Manual (this manual)
Performing the On-Site Installation
 Locate the power source for connecting the supplied power cord and attach this
power cord to Enable-IT 375. You can apply power to the unit.
 Insert a standard Ethernet patch cord to the Data/PoE out port - the other end of the
Ethernet Patch cord is for your PoE equipment or Enable-IT 865 PoE and Ethernet
Extender (Data/PoE in port)
 Insert a standard Ethernet patch cord into the Data In port and connect the other end
of the Ethernet Patch cord to your Local LAN device such as a switch.
All Rights Reserved 1997 - 2015 Enable-IT, Inc.
Page 2 of 8

Keep in mind that Ethernet data has a limit of 328ft or 100m. You can easily solve this issue
by using the Enable-IT 375 PoE Plus Injector with an Enable-IT 865 PoE Ethernet Extender
kit. Using the 865 kit will drive your PoE and data up to 3,500ft.
All Rights Reserved 1997 - 2015 Enable-IT, Inc.
Page 3 of 8

Typical Applications
Enable-IT 375 Gigabit Power over Ethernet Plus Injector unit is very lightweight and compact for
most all applications and use. These units are easy to install with plug and play RJ-45 Ethernet
jacks. Insert your wiring and go.
As an 802.3AT compliant device, the Enable-IT 375 75W - 56VDC Power over Ethernet Plus
Injector uses 4 wires in a category rated wiring bundle, i.e. CAT5e run. As with all PoE supplies,
voltage drops over distance. As a rule of thumb you will loose 2V per every 100′- 200′ of wiring,
depending on the gauge. Lower power also means more amperage which means more heat and
perhaps issues with the 24 gauge wires in CAT5. You may need to use 18 gauge wiring. The
Enable-IT 375 is a 56V power injector to maximize your distance and output.
The Enable-IT 375 Gigabit Power over Ethernet Plus Injector is suited for the following key
environments:







Commercial Buildings (Multi-Tenant Units)
Business Parks (Multi-Tenant Units)
Apartments (Multi-Residential Units)
Hotels (Multi-Hospitality Units)
Business Suites (Multi-Hospitality Units)
School Campuses (University, K-12)
College Housing (Multi-Residential Units)
Figure 1 Enable-IT 375 included with the 865PTZQ PoE & Ethernet Extender Kit
All Rights Reserved 1997 - 2015 Enable-IT, Inc.
Page 4 of 8

TECHNICAL SUPPORT
Enable-IT, Inc.’s Customer Care Team support is available directly to customers and
distributors. All support requests are processed through the online support portal. This allows
us to provide assigned support ticket numbers in order to bring closure to any technical issues.
Online Technical Services
The Enable-IT Support Portal is available 24/7 to open a ticket or check the status of one.
Please use this support website as your first source for help as it contains an on-line knowledge
base of articles, documentation, FAQ's and other problem-solving resources. This web-based
support resource provides the quickest solution to the most common technical support issues.
World Wide Web Site
http://support.enableit.com
Returning Products for Warranty Repair
Enable-IT, Inc. warrants to the original purchaser of the Product ("you" or the "End User") that,
for the four (4) year period commencing on the date the Product was purchased (the "Warranty
Period"), the Product will be substantially free from defects in materials and workmanship under
normal use and conditions. Electrical damage is not an item that is covered under this
warranty, extended warranties or Advanced Replacement Program (AREP).
In order to obtain an authorized RMA approval, the End User must complete the required
information online located at http://support.enableit.com. If you have questions or difficulty
completing this information you may contact the Customer Care Team at 888-309-0910
between the hours of 8:00 a.m. and 5:00 p.m. PT.
Please ship Authorized RMAs to:
Enable-IT Processing Facility
16600 Harbor Blvd, Suite I
Fountain Valley, CA 92708-1363
Returning Products for Refund
Enable-IT, Inc. offers a generous 45-Day refund on a single Ethernet Extender Kit only,
and is subject to a 15% Restocking Fee. Shipments without a valid or authorized RMA
number, or sent to our corporate Las Vegas address, can be refused and / or billed for
additional shipping.
All Rights Reserved 1997 - 2015 Enable-IT, Inc.
Page 5 of 8

ENABLE-IT, INC. LIMITED WARRANTY
Enable-IT, Inc. warrants the Enable-IT 375 Gigabit Power Over Ethernet Injector solely
pursuant to the following terms and conditions.
1. PRODUCT WARRANTY.
a. Express Warranty.
Enable-IT warrants to the original purchaser of the Product ("you" or the "End User") that, for
the four (4) year period commencing on the date the Product was purchased (the "Warranty
Period"), the Product will be substantially free from defects in materials and workmanship under
normal use and conditions. This warranty does not apply to Products, which are resold as
used, repaired or reconditioned, or consumables (such as batteries) supplied with the Product.
Electrical damage is not an item that is covered under this warranty or extended
warranties. Enable-IT does not make any warranty with respect to any third party product,
software or accessory supplied with or used in connection with the Product and such third party
products, software and accessories, if any, are provided "AS IS." Warranty claims related to
such third party products, software and accessories must be made to the applicable third party
manufacturer.
b. Remedies for Breach of Warranty.
In the event of a breach of the foregoing warranty, Enable-IT will, in its sole discretion and at
its cost, and subject to the terms of the following paragraph, repair the non-conforming Product,
replace the non-conforming Product with a new or reconditioned Product or refund the
purchase price for the Product. Any new or reconditioned Product provided pursuant to this
paragraph is warranted as provided herein for the remainder of the original Warranty Period.
THE REMEDY SET FORTH IN THIS PARAGRAPH SHALL BE THE END USER’S SOLE
AND EXCLUSIVE REMEDY FOR BREACH OF THE FOREGOING WARRANTY.
c. Conditions for Warranty Qualification.
If authorized by Enable-IT to return a Product which does not conform to the warranty set forth
above, the End User must: (1) obtain a return materials authorization (RMA) number from
Enable-IT by contacting the Customer Service Dept. at 888-309-0910 between the hours of
8:00 a.m. and 5:00 p.m. PST and otherwise fully comply with Enable-IT’s then-current RMA
policy; (2) return the Product to Enable-IT in its original packaging freight pre-paid; and (3)
provide to Enable-IT the original receipt or bill of sale establishing the date on which the Product
was purchased. Products returned to Enable-IT without an RMA number will be returned to
the End User. Enable-IT shall not be responsible for damage or loss during shipment of the
returned Product to Enable-IT.
d. Voiding of Warranty.
The express warranty set forth above shall not apply to failure of the Product if the Product has
been subjected to: (i) physical abuse, misuse, improper installation, abnormal use, power
failure or surge, or use not consistent with the operating instructions provided by Enable-IT; (ii)
modification (including but not limited to opening the Product housing) or repair by any party in
any manner other than as approved by Enable-IT in writing; (iii) fraud, tampering, unusual
physical or electrical stress, unsuitable operating or physical conditions, negligence or
accidents; (iv) removal or alteration of the Product serial number tag; (v) improper packaging
of Product returns; or (vi) damage during shipment (other than during the original shipment of
the Product to the End User from Enable-IT, if applicable).
e. Warranty Disclaimers.
THE EXPRESS WARRANTY SET FORTH ABOVE IS IN LIEU OF ALL OTHER
WARRANTIES, WHETHER WRITTEN, ORAL, EXPRESS OR IMPLIED. ENABLE-IT
All Rights Reserved 1997 - 2015 Enable-IT, Inc.
Page 6 of 8

DISCLAIMS, TO THE MAXIMUM EXTENT PERMITTED BY LAW, THE IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR
NONINFRINGEMENT OF THIRD PARTY RIGHTS. NO PERSON (INCLUDING WITHOUT
LIMITATION, ENABLE-IT’S EMPLOYEES, AGENTS, RESELLERS, OEMS OR
DISTRIBUTORS) IS AUTHORIZED TO MAKE ANY OTHER WARRANTY OR
REPRESENTATION CONCERNING THE PRODUCT. IF THE DISCLAIMER OF ANY
IMPLIED WARRANTY IS NOT PERMITTED BY LAW, THE DURATION OF ANY SUCH
IMPLIED WARRANTY IS LIMITED TO ONE (1) YEAR FROM THE DATE OF PURCHASE.
SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES
OR LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY MAY LAST, SO SUCH
LIMITATIONS OR EXCLUSIONS MAY NOT APPLY. THIS WARRANTY GIVES THE END
USER SPECIFIC LEGAL RIGHTS AND THE END USER MAY ALSO HAVE OTHER
RIGHTS, WHICH VARY FROM JURISDICTION TO JURISDICTION. ENABLE-IT DOES
NOT WARRANT THAT THE OPERATION OF THE PRODUCT WILL BE UNINTERRUPTED
OR ERROR FREE. ENABLE-IT IS NOT RESPONSIBLE FOR ANY DAMAGE TO OR LOSS
OF ANY PROGRAMS, DATA, OR OTHER INFORMATION STORED ON OR
TRANSMITTED USING THE PRODUCT.
2. LIMITATION OF LIABILITY.
IN NO EVENT SHALL ENABLE-IT BE LIABLE TO THE END USER, OR ANY THIRD PARTY,
FOR ANY INDIRECT, SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL
DAMAGES IN CONNECTION WITH OR ARISING OUT OF THE SALE OR USE OF THE
PRODUCT (INCLUDING BUT NOT LIMITED TO LOSS OF PROFIT, USE, DATA, OR
OTHER ECONOMIC ADVANTAGE), HOWEVER IT ARISES, INCLUDING WITHOUT
LIMITATION BREACH OF WARRANTY, OR IN CONTRACT OR IN TORT (INCLUDING
NEGLIGENCE), OR STRICT LIABILITY, EVEN IF ENABLE-IT HAS BEEN PREVIOUSLY
ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND EVEN IF A LIMITED REMEDY
SET FORTH IN THIS AGREEMENT FAILS OF ITS ESSENTIAL PURPOSE. IN NO EVENT
SHALL ENABLE-IT’S LIABILITY TO THE END USER, OR ANY THIRD PARTY, EXCEED
THE PRICE PAID FOR THE PRODUCT. BECAUSE SOME JURISDICTIONS DO NOT
ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR
INCIDENTAL DAMAGES, THE ABOVE LIMITATIONS MAY NOT APPLY TO THE END
USER.
3. LICENSE AND LIMITATIONS.
The firmware and software embedded in the Product (the "Embedded Software") are licensed
to you. Your use of the Product is your acceptance of the warranty terms above and the terms
below. You may use the Embedded Software solely in conjunction with your use of the
Product. All worldwide right, title and interest in and to the Product, or any portion thereof
(including but not limited to the Embedded Software), including all copyrights, patent rights,
trademarks, trade secrets, and other intellectual property rights therein and thereto, are and
shall remain the exclusive property of Enable-IT and/or its licensors. You acknowledge and
agree that you may not, and may not allow any third party to, (i) use the Embedded Software
in a manner that is inconsistent with the above express right granted to you or (ii) modify,
distribute, reproduce, decompile, disassemble, reverse engineer or otherwise attempt to
discover the source code for the Embedded Software.
All Rights Reserved 1997 - 2015 Enable-IT, Inc.
Page 7 of 8

CONTACT US
Sales and Customer Care:
Toll Free US and Canada
888 309-0910
866 389-8605 Fax
Other International
+1 702 924-0402
+1 702 800-2711 Fax
E Mail
sales@enableit.com
support@enableit.com
RMA Support:
http://support.enableit.com
All Rights Reserved 1997 - 2015 Enable-IT, Inc.
Page 8 of 8