Lightning Current Arrester – DC Solar Energy System, Class 1 (MOV type) LD-D62EFS General Information Class 1 Surge Protective Devices specially designed for protection of direct lightning on Solar Engy Systems. They are designed and tested to manage high energy direct lightning impulse striking the DC side of Solar Energy Systems. The Class 1 SPDs are recommended for locations defined by the LPZ concept of the standard. For example, DC power line entrance of the converter connected to the Solar cell modules. The products are generally installed at the entrance of the converter panel. Features - Large energy protection capability with superior MOV unit - Low protection level : Up < 2500V - Very fast response time ( <3nsec), Decoupling Inductance not required - Status indicator and signal contact - Materials comply to RoHS Characteristics LD-D62EFS SPD according to IEC61643-11 Class I Nominal DC voltage Un UN Circuit diagram - Max. continuous operating D.C. voltage Uc 660V Nominal discharge current In 25 kA Max. discharge current Iimp 25 kA Voltage protection level Up ≤ 2500V Response time ≤ 3ns Max. mains-side overcurrent protection ≥ 225A Short-circuit withstand capability Operating temperature range Operating state/fault indication Cross-sectional area (Min.) Cross-sectional area (Max.) For mounting on 50kA 70°C –20°C ~ + 50°C –40°C Indication bar flag 5.5㎟ Stranded 22㎟ Stranded 35㎜ DIN rails / bolt Enclosure material Polycarbonate UL94 V-0 Location category Indoor Degree of protection IP20 Poles (terminals) 1 Standards comply with IEC 61643-11 JIS C 5381-1 Connection for DC Line protection Connection to status monitoring device OTOWA / 15