Companion II Display General Assembly Instructions Note: Assembly is the same for all shapes and sizes of Companion II Frames 2. Connect poles to corners. (See diagram to on next page) 1. Straighten and assemble all bungeed poles. 3. If your kit includes a center support pole, insert it into the corresponding holes, located in the top and bottom poles of the frame. Frames over 100” wide recquire support poles 4. Lay frames down. Pull pillowcased graphic over frame and zip closed. 5. Clamp optional lights on top bar. Tip: Put lights on before standing the display up. 6. Stand frames up. Note: This step is easier with two people. 90° DL 7a. If your kit includes a single foot, attach it to bottom of frame. Secure foot with locking pin. 7b. If your kit includes a double foot labeled (DL), connect as seen above. Frame on right (shown in gree above) attaches to the front foot nub and overlaps the back frame by approximately 3.5 inches. DR 7c. If your kit includes a double foot labeled (DR), connect as seen above. Frame on left (shown in green above) attaches to the front foot nub and overlaps the back frame by approximately 3.5 inches. 7d. If your kit includes a 90 degree foot labeled (90), connect as seen above. Frame on bottom (shown in blue above) should be placed at a right angle in relation to the adjacent frame. Note: This foot does not use locking pins. Updated 2/11/2015 10’ x 20’ Foot Companion II Graphic Display J Diagram of Frames Hardware is labeled as seen in diagram below: Make sure arrows point in the same direction 56” x 87” Flat Frame 111” x 96” Flat Frame 56” x 87” Flat Frame 40” x 96” Flat Frame 40” x 96” Flat Frame 90° 90° Updated 2/09/2015