INSTRUCTION
SHEET
G L O B A L L I G H T I N G S O L U T I O N S
689-0511
E4.75RA/SA-A14 HORNET-HP/ C3M INSTALLATION
PAGE 1 OF 2
WARNING - RISK OF FIRE AND ELECTRICAL SHOCK. FIXTURE MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN
ONLY. FIXTURE IS INTENDED FOR INSTALLATION IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE, LOCAL
AND FEDERAL SPECIFICATIONS. DISCONNECT POWER AT ELECTRICAL PANEL BEFORE SERVICING.
RETAIN THESE INSTRUCTIONS FOR MAINTENANCE REFERENCE.
1
2
DIMENSIONS
E4.75RA ROUND: Ø5.375"
E4.75SA SQUARE: 5.375 X 5.375"
3
WING NUT ON
INSIDE OF HOUSING
VERTICAL ADJUSTMENT
LOOSEN WING NUT, ADJUST HEIGHT THEN TIGHTEN WING NUT.
APERTURE RING TO BE FLUSH WITH
BOTTOM OF CEILING
4
A
18.25" MIN
T-BAR 25" MAX
HORIZONTAL ADJUSTMENT WOOD
SPREAD HANGER BARS AND MOUNT TO T-BAR OR WOOD
WITH HARDWARE SUPPLIED BY OTHERS.
5
REMOVE ELECTRICAL KNOCKOUT AND MAKE
CONNECTION TO LED DRIVER
COMPRESS SPRING CLIP THEN LIFT
TRIM INTO FIXTURE HOUSING
1. LOOSEN THUMB SCREW
2. ADJUST OPTICAL HEAD
3. TIGHTEN THUMB SCREW
35°
THUMB SCREW
Amerlux, 178 Bauer Drive, Oakland NJ, 07436 T: 973-882-5010, F: 973-882-2604 www.amerlux.com

INSTRUCTION
SHEET
G L O B A L L I G H T I N G S O L U T I O N S
689-0511
E4.75RA/SA-G2 HORNET- HP MAINTENANCE
PAGE 2 OF 2
WARNING - RISK OF FIRE AND ELECTRICAL SHOCK. FIXTURE MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN
ONLY. FIXTURE IS INTENDED FOR INSTALLATION IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE, LOCAL
AND FEDERAL SPECIFICATIONS. DISCONNECT POWER AT ELECTRICAL PANEL BEFORE SERVICING.
RETAIN THESE INSTRUCTIONS FOR MAINTENANCE REFERENCE.
1. REMOVE (2X) SCREW
2. SLIDE COVER UP AND REMOVE
1 . REMOVE TRIM
2 . LOOSEN 2X #6 SCREW
SLIDE AND LIFT OPTICAL HEAD
UP AND OUT FROM BRACKET
REMOVE SCREWS (2X)
3 . PULL OPTICAL HEAD
THROUGH APERTURE HOLE
4 . DISCONNECT OPTICAL
HEAD HARNESS FROM
JUNCTION BOX HARNESS
WARNING: DO NOT LET OPTICAL HEAD ASSEMBLY HANG FREELY AS THIS MAY CAUSE DAMAGE OR INJURY
Amerlux, 178 Bauer Drive, Oakland NJ, 07436 T: 973-882-5010, F: 973-882-2604 www.amerlux.com