Page 1 of 2
04.09.13
Instructions for Installation:
E-10485 Mar Vista Sconce
Lamping Specifications:
Incandescent/Candelabra base
One, B-10, 60w max
One, G-16, 60w max
IMPORTANT! AT ALL TIMES WIRING
TO BE DONE PER NATIONAL ELECTRIC
CODES (NEC) OR APPLICABLE LOCAL
CODES
IMPORTANT | CAUTION
READ ALL INSTRUCTIONS THOROUGHLY.
TURN OFF POWER AT CIRCUIT BREAKER OR
FUSE BOX BEFORE PROCEEDING.
Step 1 Carefully unpack fixture and remove shade housing
from electrical back plate. Remove the decorative cap from the
top cover, then remove the top cover from the shade housing.
Remove knobs and separate decorative shade housing from electrical back plate.
Step 2 Turn off power at the circuit before proceeding.
Lift the mounting bracket into position over the junction box.
Orientation of the bracket is critical, mount with the arrow pointing upwards. Attach mounting bracket to the outlet box using
screws provided. (See Figure 1)
Figure 1
Step 3 Locate the fixture back plate assembly and make wire
connections: connect black fixture wire to black supply wire (load
typical); white fixture wire to white supply wire (neutral); attach
fixture ground wire to ground wire or ground screw. Use wire
connectors provided and push connections inside outlet box.
Figure 3
Step 4 Attach the electrical back plate assembly to the mounting
bracket, use caution not to pinch or damage the wire insulation
during installation process. Use provided hardware to secure the
electrical back plate to the mounting bracket. (See Figure 3)
Note: This fixture can be installed indoors our outdoors. For
outdoor applications apply a thin bead of waterproof caulking
to back plate along the sides and top edge to create a water tight
barrier between the wall and mounting bracket. Leave a gap at
the bottom so that moisture can be diverted away from back plate
and electrical components. (See Figure 4)
Step 5 Locate the decorative glass panel housing. If necessary
remove the top knob, top cover housing and internal sheet metal
reflector.
Figure 4
Figure 2
BOYD LIGHTING · 30 LIBERTY SHIP WAY SUITE 3150 · SAUSALITO CA 94965
TEL
415.778.4300 · FAX 415.778.4319 · BOYDLIGHTING.COM
Page 2 of 2
Step 6 Install decorative shade housing. Use caution not to
damage the finish on the fixture assembly or the shade housing. Align the holes in the shade housing plate with the studs
in the back plate and secure into position using decorative
knobs. (See Figure 5)
Step 7 Install the glass panels into the decorative shade housing, carefully lower glass panels into the housing and rest the
bottom edge of the glass into the lower channel. (See Figure 6)
Step 8 Retain the glass into position using the upper retainer
bracket and secure into position with thumb knobs. Repeat
this sequence for all remaining glass panels. (See Figure 7)
Step 9 Install B-10 style candelabra lamp, do not exceed the
wattage listed on the relamp label.
Figure 8
Step 10 Install the upper sheet metal reflector and secure into
position with thumb knobs. (See Figure 8)
Figure 5
Step 11 Install the upper housing cover. Carefully lower the
cover over the shade housing assembly and align the hole in
the cover with the stud hardware on the fixture assembly.
(See Figure 9)
Step 12 Secure decorative housing cover into position with the
top decorative cap. (See Figure 10)
Step 13 Restore power to circuit and illuminate lamp.
Figure 9
Figure 6
Figure 10
Figure 7
BOYD LIGHTING · 30 LIBERTY SHIP WAY SUITE 3150 · SAUSALITO CA 94965
TEL
415.778.4300 · FAX 415.778.4319 · BOYDLIGHTING.COM