RGB Color Changing Fixtures

advertisement
RGB Color Changing Fixtures
12-Lamp Studio CycSeries Fixture
Specifications
Housing
20-gauge (.0359) CRS formed, sheet metal
construction. Mineral bronze finish (Cardinal #T025BR01) is standard, with custom colors available.
Reflector
24-gauge (.020) formed aluminum substrate with a
silver-based polyester film laminate. 95% specular
reflectance.
Barn Door
Hinged to the bottom front of the fixture face. Pivots
down to 90°. Swings up to protect fixture face when
unit is not in use.
Ballasts
(6) Digital high-frequency electronic ballast for 28W to
54W (High Output option). 120 or 230VAC, 50/60Hz,
power factor > .97, class “A” sound rating, THD, 10%.
The ballasts allow dimming down to 3% without
flashing or flickering. DMX Master Unit required for
DMX to Digital protocol conversion.
Lamps
(12) 28w or 54W (HO option), available in red, green,
and blue. Red, green, and blue colored sleeves are
provided with 28W lamps for more saturated colors.
Lamp Sockets
G5, 2-inch twist-and-lock molded white high-strength
thermoplastic.
Power Entry Module
IEC-320 connector with integral 8-amp fuse and holder
for spare fuse.
DMX Master Unit
DMX in and out receptacles and digital ballast output
receptacle. The DMX start address can be set
anywhere between 1 and 512; the fixture uses three
consecutive DMX addresses. The DMX output is selfterminating; no termination switch is required. Unit is
capable of driving up to four remote units.
Remote Unit
Digital ballast input and output receptacles. Unit must
be driven by a DMX master unit. Remote units are
daisy-chained together.
Mounting Bracket
10-gauge extruded aluminum yoke for horizontal or
vertical mounting. Horizontal yoke standard; add “-V” to
part number for vertical yoke.
Power Cord
12-ft (3.66-m) length 18/3 gauge SOW cable
10amp/250V. Female IEC connector to male grounded
3-pin Edison plug (NEMA 5-15P). Black color. Optional
connectors available upon request.
Electrical Certification
cUL, CE, and C-Tick listed.
Includes
Horizontal or vertical yoke; a power cord, and C-clamp
with safety cable.
580 Mayer Street - Building # 7 - Bridgeville, PA 15017 USA
Phone: 1.412.206.0106 - Fax: 1.412.206.0146
© 2013 Brightline LP All Rights Reserved
Specifications are subject to change without notice.
RGB Color Changing Fixtures
12-Lamp Studio CycSeries Fixture
TV Studio Layout using 12-Lamp Studio CycSeries Fixtures
54’ [1646 cm]
6’ [183 cm]
10’ [305 cm]
DMX Master
10’ [305 cm]
Remote
6’ [183 cm]
10’ [305 cm]
10’ [305 cm]
Remote
DMX Master
Shipping Information
Length: 48-in (1220-mm)
Width: 22-in (559-mm)
Height: 8-in (204-mm)
Weight: 55-lb (25-kg)
Plan View
6’ [184 cm]
Notes:
These drawings show a suggested layout for using 12-lamp
Studio CycSeries fixtures in a small broadcast studio. Note the
fixture-to-fixture and the fixture-to-cyclorama distances. The
twelve-lamp version of the Studio CycSeries family of fixtures
is most suitable for studios where the illuminated section of the
cyclorama does not exceed 16-ft (488-cm) in height. Note the
placement of DMX Master and Remote units.
12-Lamp
Cyc Fixture
SC
StudioCyc
Lamp Quantity
Control
Yoke
Voltage
4.12 = Twelve Lamp
X = Master
H = Horizontal
1 = 120V
4.6 = Six Lamp
R = Remote
V = Vertical
2 = 230V
Cyclorama Curtain
Partial Section
Note: Bronze fixture finish is standard; custom-finish available (add -CF suffix to Part Number).
Note: For 12-Lamp fixtures, nine remote fixtures can be controlled by one master fixture.
580 Mayer Street - Building # 7 - Bridgeville, PA 15017 USA
Phone: 1.412.206.0106 - Fax: 1.412.206.0146
© 2013 Brightline LP All Rights Reserved
Specifications are subject to change without notice.
Download