Pedestal Riser
Overview
for Vector & Frameworx Scorers
The pedestal riser contains the necessary materials to adapt single wishbone lane consoles to an existing
conduit within either a concrete or wooden floor. If electrical conduit(s) are not present, surface mount
raceways may be used to route the low voltage cables to the base of the consoles.
Installation on Concrete Floors
Prior to installing the bottom spacer, inspect the edges and top surface area for nicks or burrs which may
affect the installation of the botom spacer.
Install the pedestal riser as follows:
1. Place the bottom spacer (part number 57-301218-000, part of package number 57-862041-xxx),
equally distant around conduit or raceway, making sure the bottom spacer is parallel to the approach. Refer to Figure 1 for proper orientation of the spacer.
Figure 1. Placement of Bottom Spacer
© Brunswick Bowling & Billiards Corp. 2012. All rights reserved.
March 2012
1
57-900130-000
2. Using the properly positioned bottom spacer as a template, drill four 1/2” (13 mm) dia. holes (that
match pedestal base mount holes) into the concrete floor to a depth of 1-9/16” (40 mm). Refer to
Figure 2.
Figure 2. Drill Holes for Concrete/Wood Anchors
3. Set the bottom spacer aside and install four Hilti concrete fasteners (part number 11-111560-000,
included in scorer mounting hardware) into the drilled holes. Refer to Figure 3.
Figure 3. Installation of Concrete Fasteners
NOTE: Installation instructions for the Hilti concrete fasteners are included in the scorer mounting
hardware package. The Hilti concrete fasteners should be installed by following these instruction
sheets.
2
4. Place the bottom spacer over the drilled holes and align the hole patterns.
5. Insert the individual cables through the appropriate openings in the top spacer (part number
57-301217-000, part of package number 57-862041-xxx). Carefully position the top spacer over
the bottom spacer as shown in Figure 4. Align the holes of the top spacer with the holes of the
bottom spacer.
Figure 4. Spacer Alignment
6. Carefully place the pedestal on top of the top spacer while feeding the cables through the bottom
of the corresponding console.
7. Align hole patterns of the pedestal base, top spacer and bottom spacer and install four
3/8-16 x 2-1/4” special hex head cap screws of the appropriate color (see chart below). Tighten
screws to secure components to the floor.
Hardware Color
Part Number
Package Number
BLACK
53-400301-001
57-862041-000
SILVER
53-400503-019
57-862041-100
8. Complete the installation of the pedestal using the appropriate installation manual.
3
Installation on Wood Floors
The following instructions pertain to installing a pedestal riser on wooden floors.
To install the pedestal riser:
1. Place the ID of the bottom spacer (part number 57-301218-000, part of package number
57-862041-xxx), equally distant around the conduit or raceway, making sure the bottom spacer is
parallel to the approach. Refer to Figure 1 for proper orientation of the spacer.
2. Using the properly positioned bottom spacer as a template, drill four 5/8” (16 mm) DIA. pilot
holes into the wooden floor to a depth of approximately 1-3/8” (35 mm). Refer to Figure 2 for
item view.
3. Set the bottom spacer aside and install four wood inserts (part number 11-095011-000, part of
package 53-860990-000), into the drilled holes. Refer to Figure 5.
Figure 5
4. Place the bottom spacer over the drilled holes and align the hole pattern.
5. Perform steps 5 through 8 under “Installation on Concrete Floors” paragraph to complete the
installation procedure.
4