Specifications Sheet
A0340SH
March 2015
Portable Handheld Shaker
Emerson’s A0340SH Portable Handheld Shaker can be used to verify the output
of accelerometers, velocity, and displacement sensors and confirm the entire
measurement chain (sensor, cabling, and monitoring system). Battery-powered
operation allows testing of online sensors in the field.
Dynamic Performance
Frequency Output
159.2 Hz (9,552 cpm)
Acceleration (rms switchable to peak)
1 g rms ±3% (9.81 m/s2)
Velocity
9.81 mm/s rms ±3% (0.39 in/s)
Displacement
9.81 μm rms ±3% (0.39 mils)
Transverse Amplitude
≤3%
Distortion (0 to 20 gram load)
<7% (hand tightened)
Environmental
Temperature Range
1/4- 28 Mtg. Hole
-10 to 55°C (15 to 130°F)
Electrical
MADE IN USA
LOW
POWER
Ramp-Up Time
≤3 seconds
Battery Power
(4) AA batteries (included)
Battery Life/Cycles (250 gram load)
2.3 hours / 90 Cycles
External Power (optional)
10 Volts (2.4 A)
Automatic Switch Off
1 to 2.5 minutes
A0340SH
SN XXXX
ON
OFF
RMS
AUTO
PEAK
CONT.
CAL (-)
CAL (+)
201 mm (7.9")
ACCEL. 1.00 g (9.81 m/s2)
FREQ. 159.2 Hz
MAX LOAD 250 grams
DC 10 VOLTS/2 AMP
Mechanical
Weight
900 g (31 oz)
Sensor Mount
1/4 -28UNF-2B
Mounting Torque (Hand Tighten)
1.12 Nm (0.83 lb ft)
55.6 mm (2.19") dia.
Included Accessories
Carrying Case
31.75 mm (1.25") diameter
7.62 mm (0.30")
30 T.P.I.
STRAIGHT KNURL
Storage Box
Battery Pack with (4) AA batteries
Calibration Mass (For sensors weighting less than 75 grams (2.64 oz))
(2) 1/4 -28UNF to ¼ 28 UNF Studs
10-32 to ¼ 28 UNF Stud
M6x1 to ¼ 28 UNF Stud
www.assetweb.com
16.51 mm (0.65")
50.8 x 0.51 x 114.3 mm (2.0 x 0.02 x 4.5")
1/4-28 UNF - 2B
Top & Bottom
Calibration Mass
Specifications Sheet
A0340SH
March 2015
©2015, Emerson Process Management.
Emerson Process Management
Reliability Solutions
835 Innovation Drive
Knoxville, TN 37932
T (865) 675-2400
www.assetweb.com
The contents of this publication are presented for informational purposes only, and while every
effort has been made to ensure their accuracy, they are not to be construed as warranties or
guarantees, express or implied, regarding the products or services described herein or their use or
applicability. All sales are governed by our terms and conditions, which are available on request.
We reserve the right to modify or improve the designs or specifications of our products at any
time without notice.
All rights reserved. Machinery Health is a mark of one of the Emerson Process Management group
of companies. The Emerson logo is a trademark and service mark of Emerson Electric Co. All other
marks are the property of their respective owners.