PACKAGING
AVAILABLE TERMINALS FOR SNAP-IN AND SCREW-MOUNT TYPE
◦We can make the following terminal type on custom design.
◦There is a restriction for specification of product, please consult with us when the product is required.
◦Please consult with us about terminal type other than those following listed.
Snap-in type
[mm]
Terminal, Dummy code : VNN
D=φ22 toφ35
D=φ30 toφ40
Terminal, Dummy code : LIN
PC board pin-out
(View from Solder side)
PC board pin-out
(View from Solder side)
5.8±1
Vent
4.2
φD+1max.
10
φD+1max.
2-1.2×6
5
2-φ2
*1
4.5±1
Vent
Terminal, Dummy code : VEN
14.2
*1
Terminal, Dummy code : VRD
D=φ30, φ35
D=φ35, φ40
PC board pin-out
(View from Solder side)
PC board pin-out
(View from Solder side)
10
4±1
2-φ2
1-φ2.5min.
*1
A
*1
5.5±1
Vent
4-φ2
B : Positive, A, C : Dummy
Terminal, Dummy code : VND
Terminal, Dummy code : LIS
D=φ35, φ40
D=φ50
PC board pin-out
(View from Solder side)
*1
Vent
4-φ2
B : Positive, A, C : Dummy
3-1.5×6.5
*1
15.5
A
4.0 +0.2
- 0.1
11.0
60
C
22.5
φD+1max.
5.8±1
Vent
PC board pin-out
(View from Solder side)
φD+1max.
60
B
A
60
60
C
22.5
4.75
Vent
B
φD+1max.
φD+1max.
3.3
26.8
A : Dummy
D=φ20×30 to 50L, φ22×30 to 50L
Horizontal mounting
Terminal, Dummy code : LCN
Negative mark
φD+1max.
PC board pin-out
(View from Solder side)
2-φ2
*1
Vent
1.5±0.1
3±1
8
8±1
*1 Negative terminal : Mesh marking
*2 Use the dummy terminals for mechanical support only.
The dummy terminals must not be connected to any circuit trace on PC board, be sure to electrically isolate from the negative and the
positive terminals.
Screw-mount type
[mm]
Stud mounting type
D=φ63.5 to φ89
Installation
Recommendation
plate thickness: 3.2mm
16.5±1
Plastic disk
Vent
Mounting
screw
M12, P=1.75
φ30±0.5
φD+1.8max.
Plastic nut
Recommendation
mounting hole: φ31±0.5
19±1
1.2±1
16±1
φ38±2
Mounting screw and case are
same potential as the cathode
terminal. Please careful of
isolation between chassis.
Please consult with us about other size.
Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications.
16
CAT. No. E1001Q