Arizer Solo Battery Replacement Instructions
1. Remove four screws from the bottom of the unit.
You will need a very small Phillips screwdriver (#00).
2. Slide the top cover up and remove it from the unit.
You may need to slightly pry it away from the bottom.
2. Using a small flat tip screwdriver,
carefully pry open the battery
compartment cover tabs on both sides of
the unit (4 total), while pushing the cover
away from the unit.
Page 1
Arizer Solo Battery Replacement Instructions
4. Remove old battery from the unit.
Disconnect the battery by pulling apart the
connector. Do not pull on the wires!!!
5. Connect new battery to the unit.
6. Power on the unit to make sure that it
works. Power off the unit.
Page 2
Arizer Solo Battery Replacement Instructions
7. IMPORTANT!!!. New battery orientation:
Connector side should be on the bottom of
the unit, flat side should be on top.
TOP
BOTTOM
8. Insert the bottom of the new battery into
the unit.
Bottom First
9. Carefully push the top of the battery into
the unit. The replacement battery is slightly
longer than the original one. It should fit very
snuggly into place.
Page 3
Arizer Solo Battery Replacement Instructions
10. Reinstall the battery cover. If it proves too difficult to snap it into place, it may be safely left
out.
11. Slide the unit back together and secure the bottom with four screws removed in step 1.
Original vs Replacement battery comparison.
Page 4