DFTG-1391
Quiz # 5: Equipment Layout
Name:________________________________
Date:_____________
1. Flammable facilities should be ____________ from important buildings and equipment.
2. Valves for emergency use on flammable fluid containers should be of the ____________
type.
3. Pump should be located close to ____________.
4. Pumps should be placed close to hot or cooled liquid sources to ____________ pipe
insulation.
5. Pump piping should be properly supported to relieve the pumps of _________ or
_____________.
6. A clear space of _______ should be provided around equipment.
7. Motor drive ends should have _______ clear space.
8. The bounding box is used to determine the basic ________ requirement for a device.
9. Tanks, vessels, and pumps should be placed on the _________ side of a pipe rack.
10. The minimum space gap between combustible or flammable liquid containers is the greater
of 3 ft. or _______________ the sum of adjacent tank diameters.
11. The minimum space gap between liquefied petroleum gas container and combustible or
flammable liquid containers is ________ .
12. NPSH stands for _________ __________________ ____________ ________.
13. The discharge center lines of parallel pumps should be _____________.
14. A minimum of ________ should be added to pump head losses for suction line losses.
15. compressors should be at least __________ from pipe rack column center line.
16. Back head line of heat exchangers should be _________ from rack column center line.
17. Reactors should be at least ________ from other equipment.
18. Manual fuel shut off valves should be ________ away.
19. Floor of vertical furnaces should be _________ from grade.
20. A minimum of _________ clear space should be provided for valve operation.
21. The ___________ vertical vessel determines the locations of others in the same unit.
22. Rack column centerline should be _______ from the edge of the largest tower in a unit.
23. All nozzles on an equipment should have the s __________ projection, except special
requirements dictate otherwise.
24. Saddle thickness should be ______ of vessel length.
25. Tube removal area minimum length should be the tube length plus _______.
Reciprocating