NZQA registered unit standard 26834 version 1 Page 1 of 3

advertisement
NZQA registered unit standard
26834 version 1
Page 1 of 3
Title
Demonstrate glider winch launch as a pilot
Level
4
Credits
1
Purpose
People credited with this unit standard are able to demonstrate
glider winch launch as a pilot.
Classification
Aviation > Aircraft Operation
Available grade
Achieved
Entry information
Critical health and
safety prerequisites
Open. However industry requirements are that the candidate
must meet the requirements laid down by Gliding New
Zealand.
Explanatory notes
1
This unit standard is aligned with the relevant parts of the prescribed syllabi of the
Qualified Glider Pilot (QGP) licence. Credit will be awarded upon meeting the
requirements of the Gliding New Zealand approved assessment or examination.
2
Industry standards and recommended practices are those set in place by Gliding
New Zealand.
3
All references to the Civil Aviation Authority (CAA) refer specifically to the New
Zealand Civil Aviation Authority.
4
Industry texts may include but are not limited to – aircraft flight manuals, Gliding New
Zealand Manual of Approved Procedures, CAA Rules, operator exposition.
5
A glider winch launch may also be referred to as a wire launch.
6
Ground launch upset refers to emergency procedures that may be encountered
during a winch launch. Emergency procedures may be real or simulated.
ServiceIQ
SSB Code 9068
 New Zealand Qualifications Authority 2016
NZQA registered unit standard
26834 version 1
Page 2 of 3
Outcomes and evidence requirements
Outcome 1
Demonstrate glider winch launch as a pilot.
Evidence requirements
1.1
Winch launch procedures are demonstrated in accordance with industry texts
and standards.
Range
ground run, lift off, rotation, safety climb, full climb, top of
climb/release.
1.2
Communication with winch operator is carried out in accordance with industry
texts and standards.
1.3
Cross wind launch is demonstrated in accordance with industry texts and
standards.
1.4
Ground launch upset is demonstrated in accordance with industry texts and
standards.
may include but is not limited to – cable break, winch failure,
release hang up, no instrument circuit.
Range
Planned review date
31 December 2015
Status information and last date for assessment for superseded versions
Process
Version Date
Last Date for Assessment
Registration
1
19 November 2010
N/A
Accreditation and Moderation Action Plan (AMAP) reference
0169
This AMAP can be accessed at http://www.nzqa.govt.nz/framework/search/index.do.
Please note
Providers must be granted consent to assess against standards (accredited) by NZQA, or
an inter-institutional body with delegated authority for quality assurance, before they can
report credits from assessment against unit standards or deliver courses of study leading
to that assessment.
Industry Training Organisations must be granted consent to assess against standards by
NZQA before they can register credits from assessment against unit standards.
Providers and Industry Training Organisations, which have been granted consent and
which are assessing against unit standards must engage with the moderation system that
applies to those standards.
ServiceIQ
SSB Code 9068
 New Zealand Qualifications Authority 2016
NZQA registered unit standard
26834 version 1
Page 3 of 3
Consent requirements and an outline of the moderation system that applies to this
standard are outlined in the Accreditation and Moderation Action Plan (AMAP). The
AMAP also includes useful information about special requirements for organisations
wishing to develop education and training programmes, such as minimum qualifications for
tutors and assessors, and special resource requirements.
Comments on this unit standard
Please contact the ServiceIQ qualifications@serviceiq.org.nz if you wish to suggest
changes to the content of this unit standard.
ServiceIQ
SSB Code 9068
 New Zealand Qualifications Authority 2016
Download