Buckeye Honors School and University Custodial Program
Proportioning System
Lesson Plan
COURSE TITLE:
Proper Use, Care and Storage of Equipment
CLASS TITLE:
Control Master II Kit
MODULE TITLE:
Proportioning System
PROGRAM OVERVIEW
This block of instruction will provide the student with hands on instruction on the Proportioning
System used with the Honors School and University Custodial Program.
PARAMETERS
Credit Hours:
Date:
15 (min)
Number of
Participants:
Target Audience:
New Employees
Required Training
Space:
Custodian Closet
PERFORMANCE OBJECTIVES
At the conclusion of this lesson, participants will:
1. The new employee will be able to
identify the parts contained in the Control
Master II Kit as well as operate the
system in accordance with the Buckeye
Honors Manual.
EVALUATION TECHNIQUE
Evaluation techniques utilized by the trainer(s) to
determine if the performance objectives have been
met.
1. Practical Evaluation, Question and
Answer
REQUIRED MATERIALS/EQUIPMENT/SUPPLIES/NEEDED
N/A
Overheads
N/A
N/A
N/A
1
1
1
Overhead Projector
Slide Show
VCR/DVD Player
DVD
Control Master II
Kit
N/A
1
N/A
N/A
N/A
Action Lock II
Connector
Computer & LCD
Television(s)
Video Camera
Masking Tape
Easel Pads & Stands
DVD: Routine Cleaning DVD Introduction to Buckeye, Disc #1. (The Action Control
System)
Other: CONTROL MASTER II KIT, ACTION CONTROL SYSTEM TO INCLUDE THE
ACTION LOCK II COLOR CODED DISPENSING HOSES.
STUDENT HANDOUTS
Title:
(1) Buckeye Honors School and University and Custodial Program Action Control
II System Handout.
(2) Custodial Procedures Manual.
INSTRUCTIONAL STRATEGIES
Discussion, Practical Application
REFERENCE(S)
The following books and / or materials were used as a basis for this lesson plan. The
instructor should be familiar with the material in these reference documents to effectively
present this module.
TITLE
TITLE
1. Honors School and University Custodial
Manual Chapter 5.1
5.
2.
6.
3.
Prerequisite
Training/Certification:
4.
N/A
Curriculum Prepared by: Ivan E. Wilson Sr.
Curriculum Content Approved by:
Date Approved
Curriculum Design Approved by:
Date Approved
Original/Revision Date
Original Date:
Revision Date:
Revision Date:
Design Notes:
Title: Proportioning Systems
Trainer Notes
1. Control Master II Kit
(a) Control Master II Proportioner
(b) Two Filling Tubes; One for Buckets, Auto
Scrubbers, Extractors. One for Grip and Go Spray
Bottles
(c) Hose Rac for hanging Action Lock II Connectors
and Filling Tubes
2. Control Master II Installation
(a) Standard Faucet with external Garden Hose
threads
(b) Attach to the faucet by screwing it on with the
connecting stem facing the front
(c) Use washers to align stem to front if necessary
Caution: The Control master II comes with a vacuum
breaker to prevent flow of chemicals into the main water
source. Do Not remove this part of the unit
3. Control Master II Operation
(a) Attach appropriate Action II Lock Connector
(b) Attach the appropriate Filling Tube to the Control
Master II to dispense a controlled flow
(c) Turn on Water
(d) For dispensing clear Water, Disconnect the
Action Lock II Connector
Caution: When Water is being used for human
consumption, make sure all Action Lock II Connectors
have been disconnected from the Control Master II
4. Action Lock II Connector Kit
(a) Color Coded
(b) Action Cap
(c) Nylon Tie
5. Action Cap Installation
(a) Carton in Upright Position, remove Shipping Cap,
Hold Spout firmly in one hand while peeling the
cap with the other hand (catch the finger tip under
the edge pulling up and back)
(b) Attach Action Cap by inserting into spout, (make
sure Cap seals flush with spout to prevent leakage
Title: Proportioning Systems
Trainer Notes
6. Action Lock II Connector Installation
(a) Design for Use With Buckeyes Action Pac, Five
Gallon Packaging Unit.
(b) Color Coded for use with specific Products and
Cleaning assignments
(c)Position the open end of the Action Lock II
Connector hose over the Action Cap and Push over the
barbs until the hose is in place
7. How to Use the Action Control II System
(a) Grasp the Action Lock II Connector on the colored
sleeve and attach it to the Control Master II
Proportioner
(c) Place one hand on the back of the Control Master
for support as you push the Action II Connector
into place.
(d) Turn on water to automatically proportion and
dispense a ready to use Solution
(e) Filling buckets or Bottles, Choose the appropriate
hose for a controlled flow
8. Importance of Proper Dilution
(a) Saves money
(b) Adding more solution could damage surface
(c) Not adding enough makes a weak solution
Caution: At no time will any person, change, manipulate,
omit or interfere with the dispensing hoses. The proper hose will
be used at all times. Disregarding this directive could result in
disciplinary action up to and including termination
Title: Proportioning Systems
Trainer Notes
Conclusion:
Control Master II Kit consist of Filling Tubes 1 for buckets and 1
for bottles
Hanging Rack
Two Position Washers
Tri- Lingual Identification Tags
How to use it
Connect to Faucet
Push Action Lock II hose with colored sleeve onto Barb
Use appropriate filling tube
Turn on Water
Fill bucket or bottle
Turn off water
Disconnect colored tube place on rack
Introduction (1min)
Proportioning System
Remember years ago how tricky it was to get the proper measurement when
mixing chemicals. Well those days of guessing are over. The hard to read
measuring cups are out, no more over pouring, no more waste. The Buckeye
School and University Custodial Program does all the measuring for you.
Buckeyes Action Control II system and Control Master Kit will allow you to
accurately dispense the products. The grip and go spray bottles meet all OSHA
standards and the label will not wash off when wet. Let’s take a look at how the
proportioning system works.