How to Collect Log Files Through the Serial Port on the Nexsan Device Document ID: 91373 Contents Introduction Prerequisites Requirements Components Used Conventions Procedure Related Information Introduction This document explains the steps to collect the log files through the serial port on the Nexsan device. Prerequisites Requirements There are no specific requirements for this document. Components Used This document is not restricted to specific software and hardware versions. Conventions Refer to Cisco Technical Tips Conventions for more information on document conventions. Procedure This is the step−by−step procedure: 1. The HyperTerminal needs to be configured as shown in order to establish the communication with the null modem cable: Baud rate 115200 Data bits 8 Parity None or 0 −−−> Depends on version of HyperTerminal Stop bits 1 Flow Control None 2. Click OK to establish communication. 3. Choose Transfer −−> Capture text at the top of the terminal window. 4. Browse to the location at which the file will be saved, and save as a text.txt file. 5. Dump the log file to the serial port: a. From the Main menu, choose Information. b. Choose System Related Information. c. Dump the event log and config to the serial port. Note: Some versions of firmware display only > Dump Event Log. d. Press Enter to dump the file. 6. Choose the number of events per page or enter the defaults. 7. Capture the events. a. Press the space bar until you reach end of the page. b. Your log file is captured to the created file. 8. If you still have issues, feel free to e−mail Technical Support at support@nexsan.com. Related Information • Physical Security and Building Systems • Technical Support & Documentation − Cisco Systems Contacts & Feedback | Help | Site Map © 2013 − 2014 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of Cisco Systems, Inc. Updated: Apr 13, 2007 Document ID: 91373