Installation Instructions
Sheet 1 of 3
Rs Surface Mount
4ft
Warning:
Before starting any work ensure that
all sources of power are turned off. All work must
meet local/national codes and be performed by a
certified electrician. Do not mount fixtures
vertically.
Exploded View and Part Call-out
#10-32 Screw
(2X)
Threaded nipple
J-Box cover
plate
Pan assembly
Rs Mounting Plate
Rs Endcap
(2X)
#10-32
screw
(4X)
Lens
Installing Mounting Plate
1/4" IPS
Nut
1/4" IPS
Nut
1/4" IPS
Nut
J-box
with power-feed
(by others)
J-box Cover
Plate
Rs Mounting
Plate
knockout for
power entry
(3X)
Threaded Nipple
for Power-feed
Fastener w/ washer
(by others)
1. Using measurements provided on following page, rough in J-box to allow wiring to run through threaded nipple and into fixture. If
necessary, use additional bracing to secure J-box.
2. Secure threaded nipple to J-box cover using 1/4" IPS nut and secure cover to J-box. Secure mounting plate to threaded nipple
using second 1/4" IPS nut.
3. Using appropriate fastener(by others), secure non-power side of mounting plate to ceiling.
ADE091118 Rev C
Installation Instructions
Sheet 2 of 3
Rs Surface Mount
4ft
Warning:
Before starting any work ensure that
all sources of power are turned off. All work must
meet local/national codes and be performed by a
certified electrician. Do not mount fixtures
vertically.
Mounting Plate Dimensions
9
45 16 "
1157.66
25
22 32 "
578.78
3
4"
19.41
13
2 32 "
60.85
3
3 32 "
13
6 32 "
78.39
162.63
1
42 2 "
1079.53
1
48 2 "
1231.50
Wiring the Fixture
Mounting Plate
#10-32 Screws
(4X)
Power-feed
from J-box
Lens Endcap
Pan Assembly
1. After securing mounting plate to ceiling, attach appropriate wires to ballast in pan assembly and ensure all connections are
properly matched. Ensure to attach GROUND wire from ballast to power-feed ground.
2. Secure pan assembly to mounting plate using all four #10-32 screws in corners of lens endcap.
ADE091118 Rev C
Installation Instructions
Sheet 3 of 3
Rs Surface Mount
4ft
Warning:
Before starting any work ensure that
all sources of power are turned off. All work must
meet local/national codes and be performed by a
certified electrician. Do not mount fixtures
vertically.
Installing Lamps into Fixture
4' T5
Lamps
(2X)
Lens
1. To install or change lamps, carefully remove lens and store in a safe place.
2. Carefully slide lamps into sockets and twist to fully secure lamps.
3. Carefully replace lens.
ADE091118 Rev C