CORELITE DESCRIPTION A unique alternative to the traditional fluorescent "wrap-around" fixture, the Class Rs Surface features a minimalistic profile with maximum architectural appeal, ideal for low ceiling applications. The Class Rs Surface utilizes the same efficient center optics found in the Class R recessed series for controlled brightness while offering a linear suspended or surface-mounted solution to complete any Class R project with a cohesive appearance. Type Catalog # Project Date Comments Prepared by SPECIFICATION FEATURES A ... Construction Formed 20 gauge steel gear tray mounts to shielding via 2 factory supplied clips. B ... End Caps Injection-molded plastic end caps. C ... Reflectors High reflectance white powder coat painted reflector system. A D ... Shielding Clear acrylic lens (no prisms) with rectangular or round perforated shield. Lens secured to housing via injection molded inserts for easy lamp access. E ... Electrical T5 fixtures are pre-wired with quick wire connectors and use UL listed Class P, T5 program rapid start universal voltage electronic ballasts, power factor of 97% with less than 10% THD. Fixtures and electrical components certified to UL and CUL standards. C E Mounting Class Rs is for individual surface mounting only. Luminaire requires 2 factory supplied formed steel painted mounting clips to be installed to structure with hardware by others (see installation instructions). Fixture then temporarily hangs onto clips to allow hands-free wiring, then fixture swings into place and is ultimately secured by factory supplied hardware. B D END CAP 1-3/4" [44mm] 5/8" [16.85mm] CLASS Rs Rectangular Perf Round Perf 6" [152mm] 2T5 Surface M O D U L E S A N D D I M E N S I O N S* Direct 48" [1219mm] Light Distribution * Indirect - 0.0% Direct - 100% ORDERING INFORMATION Sample Number: RB-WP-2N5-1C-UNV-SU Series RB=Class Rs Surface Reflector W=White Notes: Shielding L=Linear Prismatic Lens B=Micro Baffle D=Round Perf Inlay Lamp Type2 N5= T5 Normal Output G=Rectangular Perf Inlay Number of Circuits 1=1 Circuit Number of Lamps 2=2 Lamps 2=2 Circuits Wiring B=Battery Pack Voltage 120=120V C=Standard Circuit D=Dimming / Step Dimming 277=277V 347=347V E=Emergency T=Nightlight Suspension SU-JB=Surface Mount Options SD=Step Dimming1 UNV=Universal (120V-277V) Y=Daylight 1. Must specify "D" for Wiring. 2. T5 High Output lamping not available. Specifications and Dimensions subject to change without notice. Consult your representative for additional options and finishes. ADE090330 06/29/2015 3:59:45 PM