VAW SERIES (L-810) OBSTRUCTION LIGHT
SINGLE AND DOUBLE FIXTURE
INSTALLATION INSTRUCTIONS AND PARTS LIST
IF 1558
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
INSTALLATION - SINGLE HEAD UNITS (P/N 43958)
WARNING
De-energize circuit before relamping or working on fixture
A) Single fixtures (Figure 1) are supplied from factory fully assembled with
the exception of the lamp and glass globe. To facilitate wire connections,
the globe support can be disassembled from the fixture body by
loosening the thumbscrew. NOTE: A safety chain is provided attaching
the globe support ring to the base of the fixture body to assist with
assembly and re-lamping.
(B) Install the fixture housing and pull supply wires to connect with wire
leads inside fixture housing using methods that comply with NEC, CEC
and any local codes.
(C) Re-Install the globe support and tighten the thumbscrew securely to hold
support in place.
(D) Install lamp into lamp socket. Place the globe over the fixture body and
thread until globe seats tightly against gasket.
(E) If fixture has been ordered with optional wireguard (suffix-“GG”), place
the wireguard assembly over the globe until it seats into fixture housing.
Tighten the 4 thumbscrews provided with wireguard to hold it in place.
(F) To install or replace the lamp, it is not necessary to remove the globe.
Re-lamping is easily accomplished by loosening the thumbscrew and
removing globe support ring with globe together as an assembly.
FIGURE - 1 P/N 43958
INSTALLATION – DOUBLE HEAD UNITS (P/N 43961 AND 43950A)
A) Double Head fixtures (Figure 2) and globe assembly is the same as
the single fixture procedure.
(B) Feed lead wires from both fixture heads into the center section of
housing and pull wires through bottom for connection to power supply
wires using methods that comply with NEC, CEC and any local codes.
(C) P/N 43950A units include an adjustable guide arm for attachment to
housing. The guide arm facilitates connection to an obstruction light
lowering system as necessary. Incoming power wiring is made
through the top of fixture body on this model.
R E P L A C E M E N T PA R T S L I S T
Item No.
Part No.
Description
1
2
3
4
5
KL848
1 3 B 11 - 3 9 3
0600190
10047-1577
10047-2145
Globe, Red
Gasket, Globe
R e c e p ta c l e , M e d . S c r e w
L a m p , 11 6 Wa t t , 1 2 0 V
L a m p , 11 6 Wa t t , 2 3 0 V
FIGURE - 2 P/N 43961
All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable. The accuracy or
completeness thereof are not guaranteed. In accordance with Crouse-Hinds "Terms and Conditions of Sale", and since conditions of use are outside our control,
the purchaser should determine the suitability of the product for his intended use and assumes all risk and liability whatsoever in connection therewith.
Cooper Industries Inc.
Crouse-Hinds Division
PO Box 4999, Syracuse, New York 13221 • U.S.A.
Copyright© 2008, Cooper Industries, Inc.
IF 1558
Rev 1
New 2/08
Page 1